WARNING: Negative undershoots below -0.3V while the part is in battery-backed mode can cause loss of data.
Note 1: Limits at -40°C are guaranteed by design and not production tested.
Note 2: All voltages are referenced to ground.
Note 3: The use of the 250Ω trickle-charge resistor is not allowed at V
CC
> 3.63V and should not be enabled. Use of the diode is
not recommended for V
CC
< 3.0V.
Note 4: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A5h.
Note 5: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A6h.
Note 6: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A7h.
Note 7: SCLK, DIN, CS on DS1390/DS1391/DS1394; SCLK, and CE on DS1392/DS1393.
Note 8: DOUT, SQW/INT (DS1390/DS1393/DS1394), SQW, and INT (DS1392).
Note 9: The RST pin has an internal 50kΩ (typ) pullup resistor to V
CC
.
Note 10: I
CCA
—SCLK clocking at max frequency = 4MHz for 3V and 3.3V versions; 1MHz for 1.8V version; RST (DS1391/DS1393)
inactive. Outputs are open.
Note 11: Specified with bus inactive.
Note 12: Measured with a 32.768kHz crystal attached to X1 and X2. Typical values measured at +25°C and 3.0V
BACKUP
.
Note 13: With 50pF load.
Note 14: Measured at V
IH
= 0.7 x V
DD
or V
IL
= 0.2 x V
DD
, 10ns rise/fall times.
Note 15: Measured at V
OH
= 0.7 x V
DD
or V
OL
= 0.2 x V
DD
. Measured from the 50% point of SCLK to the V
OH
minimum of SDO.
Note 16: The parameter t
OSF
is the time that the oscillator must be stopped for the OSF flag to be set over the voltage range of
0 ≤ V
CC
≤ V
CC(MAX)
and 1.3V ≤ V
BACKUP
≤ 5.5V.
Note 17: This delay applies only if the oscillator is enabled and running. If the EOSC bit is 1, the startup time of the oscillator is
added to this delay.
