Data Sheet ADCMP606/ADCMP607
Rev. C | Page 7 of 14
PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS
Q
1
V
EE
2
V
P
3
Q
6
V
CCI
/V
CCO
5
V
N
4
ADCMP606
TOP VIEW
(Not to Scale)
05917-002
Figure 3. ADCMP606 Pin Configuration
Table 5. ADCMP606 (6-Lead SC70) Pin Function Descriptions
Pin No. Mnemonic Description
1 Q
Noninverting Output. Q is at logic high if the analog voltage at the noninverting input, V
P
, is greater than
the analog voltage at the inverting input, V
N
.
2 V
EE
Negative Supply Voltage.
3 V
P
Noninverting Analog Input.
4 V
N
Inverting Analog Input.
5 V
CCI
/V
CCO
Input Section Supply/Output Section Supply. Shared pin.
6
Q
Inverting Output. Q
is at logic low if the analog voltage at the noninverting input, V
P
, is greater than the
analog voltage at the inverting input, V
IN
.
V
CCO
V
CCI
V
EE
V
P
V
EE
V
N
V
EE
LE/HYS
S
DN
Q
V
EE
Q
9
8
7
1
2
3
4
5
6
12
11
10
05917-003
ADCMP607
TOP VIEW
NOTES
1. EXPOSED PAD. IF CONNECTED, THE EPAD MUST BE CONNECTED TO
EE
.
THE METALLIC BACK SURFACE OF THE PACKAGE IS ELECTRICALLY
CONNECTED TO
EE
. IT CAN BE LEFT FLOATING BECAUSE PIN 3, PIN 5,
PIN 9, AND PIN 11 PROVIDE ADEQUATE ELECTRICAL CONNECTION. IT CAN
ALSO BE SOLDERED TO THE APPLICATION BOARD IF IMPROVED THERMA
AND/OR MECHANICAL STABILITY IS DESIRED.
Figure 4. ADCMP607 Pin Configuration
Table 6. ADCMP607 (12-Lead LFCSP) Pin Function Descriptions
Pin No. Mnemonic Description
1 V
CCO
Output Section Supply.
2 V
CCI
Input Section Supply.
3, 5, 9, 11 V
EE
Negative Supply Voltage.
4 V
P
Noninverting Analog Input.
6 V
N
Inverting Analog Input.
7 S
DN
Shutdown. Drive this pin low to shut down the device.
8 LE/HYS Latch/Hysteresis Control. Bias with resistor or current for hysteresis adjustment; drive low to latch.
10
Q
Inverting Output. Q is at logic low if the analog voltage at the noninverting input, V
P
, is greater than the
analog voltage at the inverting input, V
N
, if the comparator is in compare mode.
12 Q
Noninverting Output. Q is at logic high if the analog voltage at the noninverting input, V
P
, is greater than
the analog voltage at the inverting input, V
N
, if the comparator is in compare mode.
EPAD
Exposed Pad. If connected, the EPAD must be connected to V
EE
. The metallic back surface of the package
is electrically connected to V
EE
. It can be left floating because Pin 3, Pin 5, Pin 9, and Pin 11 provide
adequate electrical connection. It can also be soldered to the application board if improved thermal
and/or mechanical stability is desired.
