Additive Jitter at 2.5 V*
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
RMS (fs)
Notes
1 125 12 kHz - 20 MHz 112
2 212.5 12 kHz - 20 MHz 80
3 311.04 12 kHz - 20 MHz 70
4 425 12 kHz - 20 MHz 65
5 500 12 kHz - 20 MHz 56
6 622.08 12 kHz - 20 MHz 43
7 750 12 kHz - 20 MHz 39
Additive Jitter at 3.3 V*
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
RMS (fs)
Notes
1 125 12 kHz - 20 MHz 112
2 212.5 12 kHz - 20 MHz 82
3 311.04 12 kHz - 20 MHz 72
4 425 12 kHz - 20 MHz 63
5 500 12 kHz - 20 MHz 52
6 622.08 12 kHz - 20 MHz 43
7 750 12 kHz - 20 MHz 39
ZL40200 Data Sheet
20
Microsemi Corporation
5.0 Performance Characterization
*The values in this table were taken with an approximate slew rate of 0.8 V/ns.
*The values in this table were taken with an approximate slew rate of 0.8 V/ns.
* Th
e values in this table are the additive periodic jitter caused by an interfering tone typically caused by a switching power supply. For this test,
measurements were taken over the full temperature and voltage range for V
DD
= 3.3 V. The magnitude of the interfering tone is measured at the
DUT.
Additive Jitter from a Power Supply Tone*
Carrier
Frequency
(MHz)
Parameter Typical Units Notes
125MHz 25 mV
at 100 kHz
159 fs RMS
750MHz 25 mV
at 100 kHz
82 fs RMS
