DATA SHEET • SE2611T: 2.4 GHZ HIGH EFFICIENCY WIRELESS LAN/BT FRONT END
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
202404B • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • May 30, 2014 3
Table 2. SE2611T Absolute Maximum Ratings (Note 1)
Parameter Symbol Minimum Maximum Units
Supply voltage on VCC VCC 0.3 +6 V
DC input on EN VIN 0.3 +3.6 V
Tx input power. ANT terminated in 50 match PTXIN 5 dBm
Operating temperature range TA 40 +85 C
Storage temperature range TSTG 40 +150 C
Electrostatic discharge:
Human Body Model (HBM), Class 1C
ESD
1000
V
Note 1: Exposure to maximum rating conditions for extended periods may reduce device reliability. There is no damage to device with only one parameter set at the limit and all other
parameters set at or below their nominal value. Exceeding any of the limits listed here may result in permanent damage to the device.
CAUTION: Although this device is designed to be as robust as possible, electrostatic discharge (ESD) can damage this device. This device
must be protected at all times from ESD. Static charges may easily produce potentials of several kilovolts on the human body
or equipment, which can discharge without detection. Industry-standard ESD precautions should be used at all times.
Table 3. SE2611T Recommended Operating Conditions
Parameter Symbol Minimum Typical Maximum Units
Ambient temperature TA 40 25 85 C
Supply voltage, relative to GND = 0 V VCC 2.7 3.3 4.8 V
Table 4. SE2611T Electrical Specifications: DC Characteristics (Note 1)
(V
CC = VPEN = 3.3 V, TA = +25 C, as Measured on SE2611T-EK1 Evaluation Board, All Unused Ports Terminated with 50 , Unless
Otherwise Noted)
Parameter Symbol Test Condition Min Typ Max Units
Total supply current ICC_G POUT = 18 dBm, 54 Mbps OFDM signal, 64QAM 185 210 mA
Total supply current ICC_B POUT = 20 dBm, 11 Mbps CCK signal, BT = 0.45 215 248 mA
Quiescent current ICQ No RF 133 165 mA
Total supply current ICC_OFF PEN = 0 V, no RF applied, CBTR = CBTB = CTX =CRX= 0 V
5 10
A
Total supply current ICC_LNA LEN = VCC
8 12 mA
Total supply current in bypass mode ICC_LNA_BYP LEN = 0 V
250 280
A
Note 1: Performance is guaranteed only under the conditions listed in this table.
Table 5. SE2611T Electrical Specifications: Control Logic Characteristics (Note 1)
(V
CC = VPEN = 3.3 V, TA = +25 C, as Measured on SE2611T-EK1 Evaluation Board, All Unused Ports Terminated with 50 , Unless
Otherwise Noted)
Parameter Symbol Test Condition Min Typical Max Units
Logic high voltage VIH 1.2
3.3 V
Logic low voltage VIL
0
0.4 V
Input current logic high voltage IIH
10
A
Input current logic low voltage IIL
1
A
Note 1: Performance is guaranteed only under the conditions listed in this table.
