32 Altera Corporation
FLEX 6000 Programmable Logic Device Family Data Sheet
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input is –0.5 V. During transitions, the inputs may undershoot to –2.0 V or overshoot to 7.0 V for
input currents less than 100 mA and periods shorter than 20 ns.
(3) Numbers in parentheses are for industrial-temperature-range devices.
(4) Maximum V
CC
rise time to 100 ms. V
CC
must rise monotonically.
(5) Typical values are for T
A
= 25° C and V
CC
= 5.0 V.
(6) These values are specified under the FLEX 6000 Recommended Operating Conditions shown in Table 12 on
page 31.
(7) The I
OH
parameter refers to high-level TTL or CMOS output current.
(8) The I
OL
parameter refers to low-level TTL, PCI, or CMOS output current. This parameter applies to open-drain pins
as well as output pins.
(9) Capacitance is sample-tested only.
Table 13. FLEX 6000 5.0-V Device DC Operating Conditions Notes (5), (6)
Symbol Parameter Conditions Min Typ Max Unit
V
IH
High-level input voltage 2.0 V
CCINT
+ 0.5 V
V
IL
Low-level input voltage –0.5 0.8 V
V
OH
5.0-V high-level TTL output
voltage
I
OH
= –8 mA DC, V
CCIO
= 4.75 V (7) 2.4 V
3.3-V high-level TTL output
voltage
I
OH
= –8 mA DC, V
CCIO
= 3.00 V (7) 2.4 V
3.3-V high-level CMOS output
voltage
I
OH
= –0.1 mA DC, V
CCIO
= 3.00 V (7) V
CCIO
–0.2 V
V
OL
5.0-V low-level TTL output
voltage
I
OL
= 8 mA DC, V
CCIO
= 4.75 V (8) 0.45 V
3.3-V low-level TTL output
voltage
I
OL
= 8 mA DC, V
CCIO
= 3.00 V (8) 0.45 V
3.3-V low-level CMOS output
voltage
I
OL
= 0.1 mA DC, V
CCIO
= 3.00 V (8) 0.2 V
I
I
Input pin leakage current V
I
= V
CC
or ground (8) –10 10 µA
I
OZ
Tri-stated I/O pin leakage current V
O
= V
CC
or ground (8) –40 40 µA
I
CC0
V
CC
supply current (standby) V
I
= ground, no load 0.5 5 mA
Table 14. FLEX 6000 5.0-V Device Capacitance Note (9)
Symbol Parameter Conditions Min Max Unit
C
IN
Input capacitance for I/O pin V
IN
= 0 V, f = 1.0 MHz
8pF
C
INCLK
Input capacitance for dedicated input V
IN
= 0 V, f = 1.0 MHz
12 pF
C
OUT
Output capacitance V
OUT
= 0 V, f = 1.0 MHz
8pF
