IB IL SGI 2/P-PAC
7647_en_04 28
PHOENIX CONTACT GmbH & Co. KG • 32823 Blomberg • Germany
www.phoenixcontact.com
20.12 "Diag State" object
The elements of this object are used for a structured message
of an error.
Object description:
Value range:
21 PCP mode error messages
The terminal error messages have the parameters
Error_Class = 8 (device-specific error) and Error_Code = 0
(no communication error).
The exact error cause is indicated with the Additional Code.
The low byte of the Additional Code specifies the error cause.
The high byte of the Additional Code (xx) contains the number
of the affected element. If several elements are affected, the
highest number is given.
The following Additional Codes can occur on this terminal:
22 Startup and measuring jumper de-
tuning
To start the terminal, proceed as follows:
• Install the terminal within the Inline station.
To do so, proceed as described in the package slip.
vor.
• Connect the strain gauge in 6 or 4-wire technology (see
"Connection examples").
• Connect the voltage to the Inline station.
This power up configures the terminal with the default val-
ues.
• If you do not wish to operate the terminal with the default
values, configure the terminal via process data or PCP.
• Jumper detuning can now be measured.
Object Diag State
Access Read
Data type Record 6
Index 0018
hex
Subindex
00
hex
Read all elements
01
hex
Error Number Unsigned 16
02
hex
Priority Unsigned 8
03
hex
Channel Unsigned 8
04
hex
Error code Unsigned 16
05
hex
More infor-
mation fol-
lows
Unsigned 8
06
hex
Text (10 char-
acters)
Visible String
Length
(bytes)
11
hex
Subindex 00
hex
02
hex
Subindex 01
hex
01
hex
Subindex 02
hex
01
hex
Subindex 03
hex
02
hex
Subindex 04
hex
01
hex
Subindex 05
hex
0A
hex
Subindex 06
hex
Data Diagnostic status
Error Number 0 ... 65535
dec
Priority Error code = 0000
hex
Prio: 00
hex
Other Prio: 02
hex
Channel Error code = 0000
hex
Channel: 00
hex
Other 01
hex
or 02
hex
Error code
0000
hex
OK
8910
hex
Overrange
8920
hex
Underrange
7710
hex
Line break
5160
hex
Power fail
5010
hex
Hardware fault
More infor-
mation fol-
lows
00
hex
Text (10 char-
acters)
Error code = 0000
hex
Text: Status OK
Other Error-specific
xx20
hex
Service cannot be executed at present.
xx21
hex
Service cannot be executed at present.
xx30
hex
Value out of range or reserved bits used
0000
hex
Hardware fault
For information on PCP communication,
please refer to the PCP user manuals (see Or-
dering data).
If a sensor is connected after power up, the cor-
responding channel must be configured. After
the configuration the channel is ready for oper-
ation.
