2016 Microchip Technology Inc. Advance Information DS40001835A-page 1
PIC16(L)F153XX
Description
PIC16(L)F153XX microcontrollers feature Intelligent Analog, Core Independent Peripherals (CIPs) and communication
peripherals combined with eXtreme Low-Power (XLP) for a wide range of general purpose and low-power applications.
The family features PWMs, multiple communication, temperature sensor and memory features like Memory Access
Partition (MAP) and Device Information Area (DIA). The products are offered in a broad range of pin counts from 8 to
48 pins, to support customers in various applications.
Core Features
• C Compiler Optimized RISC Architecture
• Only 49 Instructions
• Operating Speed:
- DC – 32 MHz clock input
- 125 ns minimum instruction cycle
• Interrupt Capability
• 16-Level Deep Hardware Stack
•Timers:
- 8-bit (TMR2) with Hardware Limit Timer
(HLT) Extension
- 16-bit (TMR0/1)
• Low-Current Power-on Reset (POR)
• Configurable Power-up Timer (PWRTE)
• Brown-out Reset (BOR) with Fast Recovery
• Low-Power BOR (LPBOR) Option
• Windowed Watchdog Timer (WWDT):
- Variable prescaler selection
- Variable window size selection
- All sources configurable in hardware or software
• Programmable Code Protection
Memory
• Up to 28 KB Flash Program Memory
• Up to 2 KB Data SRAM Memory
• Direct, Indirect and Relative Addressing modes
• Memory Access Partition (MAP):
- Write protect
- Customizable Partition
• Device Information Area (DIA)
Operating Characteristics
• Operating Voltage Range:
- 1.8V to 3.6V (PIC16LF153XX)
- 2.3V to 5.5V (PIC16F153XX)
• Temperature Range:
- Industrial: -40°C to 85°C
- Extended: -40°C to 125°C
Power-Saving Functionality
• Doze mode:
- Ability to run CPU core slower than the
system clock
• Idle mode:
- Ability to halt CPU core while internal
peripherals continue operating
• Sleep mode:
- Lowest power consumption
• Peripheral Module Disable (PMD):
-
Ability to disable hardware module to minimize
power consumption of unused peripherals
eXtreme Low-Power (XLP) Features
• Sleep mode: 50 nA @ 1.8V, typical
• Watchdog Timer: 500 nA @ 1.8V, typical
• Secondary Oscillator: 500 nA @ 32 kHz
• Operating Current:
- 8 uA @ 32 kHz, 1.8V, typical
- 32 uA/MHz @ 1.8V, typical
Digital Peripherals
• Four Configurable Logic Cells (CLCs):
- Integrated combinational and sequential logic
• Complementary Waveform Generator (CWG):
- Rising and Falling edge dead-band control
- Full-bridge, half-bridge, 1-channel drive
- Multiple signal sources
• Two Capture/Compare/PWM (CCP) modules
• Four 10-bit PWMs
• Numerically Controlled Oscillator (NCO):
- Generates true linear frequency control and
increased frequency resolution
- Input Clock: 0 Hz < f
NCO < 32 MHz
- Resolution: f
NCO/220
• Peripheral Pin Select (PPS):
- Enables pin mapping of digital I/O
Cost-Effective 8 to 48 Pins Microcontroller Product Brief
