PSR-MS60
106171_en_02 PHOENIX CONTACT 9
11 Mounting and connection
Mount the module on a 35 mm DIN rail according to
EN60715.
Figure 7 Mounting and removing
Connect the cables to the connection terminal blocks using
a screwdriver.
Figure 8 Connection of the cables
12 Startup
Apply the rated control supply voltage (24VDC) at terminal
blocks A1/A2. The PWR LED lights up.
Close sensor circuit 24V/S12 and 24V/S22. The IN LED
lights up.
The K1/K2 LED lights up.
If the rated control supply voltage drops, the enabling cur-
rent paths of the output circuits (13/14 and 23/24) open and
the contacts enter the safe state.
If a channel to the sensor circuit is opened (24V/S12 or
24V/S22) the corresponding enabling current path opens
(13/14 or 23/24).
For compliance with UL approval, use copper
wire that is approvedupto 60°C/75°C.
A
B
0,5-0,6 Nm
5-7 lb In
12 mm
AWG 26-12
0,2-2,5 mm
2
The sensor circuits are assigned to the en-
abling current paths as follows:
S12 to 13/14 and S22 to 23/24
(see block diagram).
This means:
If only sensor circuit S12 opens, only enabling
current path 13/14 is opened.
If sensor circuit S22 also opens, enabling cur-
rent path 23/24 is also opened.
