24
COMMERCIAL TEMPERATURE RANGE
IDT72V3653/72V3663/72V3673 3.3V CMOS SyncFIFO
TM
WITH
BUS-MATCHING 2,048 x 36, 4,096 x 36, and 8,192 x 36
NOTES:
1. tSKEW1 is the minimum time between a rising CLKB edge and a rising CLKA edge for FF to transition HIGH in the next CLKA cycle. If the time between the rising CLKB edge and rising
CLKA edge is less than tSKEW1, then FF may transition HIGH one CLKA cycle later than shown.
2. If Port B size is word or byte, tSKEW1 is referenced from the rising CLKB edge that reads the last word or byte of the long word, respectively.
Figure 14.
FFFF
FFFF
FF
Flag Timing and First Available Write when FIFO is Full (IDT Standard Mode)
NOTES:
1. tSKEW2 is the minimum time between a rising CLKA edge and a rising CLKB edge for AE to transition HIGH in the next CLKB cycle. If the time between the rising CLKA edge and rising
CLKB edge is less than tSKEW2, then AE may transition HIGH one CLKB cycle later than shown.
2. FIFO Write (CSA = LOW, W/RA = LOW, MBA = LOW), FIFO read (CSB = LOW, W/RB = HIGH, MBB = LOW). Data in the FIFO output register has been read from the FIFO.
3. If Port B size is word or byte, AE is set LOW by the last word or byte read from the FIFO, respectively.
Figure 15. Timing for
AEAE
AEAE
AE
when the FIFO is Almost-Empty (IDT Standard and FWFT Modes).
CSB
EF
W/RB
MBB
ENB
B0-B35
CLKB
FF
CLKA
CSA
4662 drw16
W/RA
A0-A35
MBA
ENA
12
t
CLK
t
CLKH
t
CLKL
t
ENS2
t
ENH
t
A
t
SKEW1
t
CLK
t
CLKL
t
ENS2
t
ENS2
t
DS
t
ENH
t
ENH
t
DH
To FIFO
Previous Word in FIFO Output Register
Next Word From FIFO
LOW
HIGH
LOW
HIGH
LOW
HIGH
(1)
FIFO Full
WFF
WFF
t
t
t
CLKH
AE
CLKA
ENB
4662 drw 17
ENA
CLKB
2
1
t
ENS2
t
ENH
t
SKEW2
t
PAE
t
PAE
t
ENS2
t
ENH
X Words in FIFO
(X+1) Words in FIFO
(1)
