ADuM140D/ADuM140E Data Sheet
Rev. 0 | Page 12 of 18
Truth Tables
Table 16. ADuM140D Truth Table (Positive Logic)
V
Ix
Input
1, 2
V
DISABLE1
Input
1, 2
V
DDI
State
2
V
DDO
State
2
Default Low (D0),
3
V
Ox
Output
1, 2
Default High (D1),
3
V
Ox
Output
1, 2
Test Conditions/
Comments
L L or NC Powered Powered L L Normal operation
H L or NC Powered Powered H H Normal operation
X H Powered Powered L H
Inputs disabled,
fail-safe output
X
4
X
4
Unpowered Powered L H Fail-safe output
X
4
X
4
Powered Unpowered Indeterminate Indeterminate
1
H means high, L means low, X means don’t care, and NC means not connected.
2
V
Ix
and V
Ox
refer to the input and output signals of a given channel (A, B, C, or D). V
DISABLE1
refers to the input disable signal on the same side as the V
Ix
inputs. V
DDI
and
V
DDO
refer to the supply voltages on the input and output sides of the given channel, respectively.
3
D0 is the ADuM140D0 model and D1 is the ADuM140D1 model. See the Ordering Guide section.
4
Input pins (V
Ix
, DISABLE
1
, and V
E2
) on the same side as an unpowered supply must be in a low state to avoid powering the device through its ESD protection circuitry.
Table 17. ADuM140E Truth Table (Positive Logic)
V
Ix
Input
1, 2
V
Ex
Input
1, 2
V
DDI
State
2
V
DDO
State
2
Default Low (E0),
3
V
Ox
Output
1, 2
Default High (E1),
3
V
Ox
Output
1, 2
Test Conditions/
Comments
L H or NC Powered Powered L L Normal operation
H H or NC Powered Powered H H Normal operation
X L Powered Powered Z Z Outputs disabled
L H or NC Unpowered Powered L H Fail-safe output
X
4
L
4
Unpowered Powered Z Z Outputs disabled
X
4
X
4
Powered Unpowered Indeterminate Indeterminate
1
H means high, L means low, X means don’t care, and NC means not connected, and Z means high impedance.
2
V
Ix
and V
Ox
refer to the input and output signals of a given channel (A, B, C, or D). V
DISABLE1
refers to the input disable signal on the same side as the V
Ix
inputs. V
DDI
and
V
DDO
refer to the supply voltages on the input and output sides of the given channel, respectively.
3
E0 is the ADuM140E0 model and E1 is the ADuM140E1 model. See the Ordering Guide section.
4
Input pins (V
Ix
, DISABLE
1
, and V
E2
) on the same side as an unpowered supply must be in a low state to avoid powering the device through its ESD protection circuitry.