Philips Semiconductors Product data
74AVC16835A
18-bit registered driver with
Dynamic Controlled Outputs (3-State)
2002 Mar 15
4
168-pin SDR SDRAM DIMM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
The PLL clock distribution device and AVCM registered drivers reduce
signal loads on the memory controller and prevent timing delays and
waveform distortions that would cause unreliable operation
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
SDRAM
74AVC16835A PCK2509S or PCK2510S74AVC16835A
BACK SIDE
FRONT SIDE
74AVC16835A
SW00726
RECOMMENDED OPERATING CONDITIONS
SYMBOL PARAMETER CONDITIONS MIN MAX UNIT
1.65 1.95
DC supply voltage (according to JEDEC Low Voltage Standards) 2.3 2.7 V
CC
3.0 3.6
DC supply voltage (for low voltage applications) 1.2 3.6 V
V
I
DC Input voltage range 0 3.6 V
DC output voltage range; output 3-State 0 3.6
O
DC output voltage range; output HIGH or LOW state 0 V
CC
T
amb
Operating free-air temperature range –40 +85 °C
V
CC
= 1.65 to 2.3 V 0 30
t
r
, t
f
Input rise and fall times V
CC
= 2.3 to 3.0 V 0 20 ns/V
V
CC
= 3.0 to 3.6 V 0 10
ABSOLUTE MAXIMUM RATINGS
In accordance with the Absolute Maximum Rating System (IEC 134). Voltages are referenced to GND (ground = 0V).
SYMBOL
PARAMETER CONDITIONS RATING UNIT
V
CC
DC supply voltage –0.5 to +4.6 V
I
IK
DC input diode current V
I
t0 –50 mA
V
I
DC input voltage For all inputs
1
–0.5 to 4.6 V
I
OK
DC output diode current V
O
uV
CC
or V
O
t 0
"50
mA
V
O
DC output voltage; output 3-State Note 1 –0.5 to 4.6 V
V
O
DC output voltage; output HIGH or LOW state Note 1 –0.5 to V
CC
+0.5 V
I
O
DC output source or sink current V
O
= 0 to V
CC
"50
mA
I
GND
, I
CC
DC V
CC
or GND current
"100
mA
T
stg
Storage temperature range –65 to +150 °C
P
TOT
Power dissipation per package
–plastic thin-medium-shrink (TSSOP)
For temperature range: –40 to +125°C
above +55°C derate linearly with 8 mW/K 600
mW
NOTE:
1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.