16
QT113B [DATASHEET]
9525D–AT42–05/2013
5. Specifications
5.1 Absolute Maximum Specifications
5.2 Recommended Operating Conditions
5.3 DC Specifications
Vdd = 3.0 V, C
S
= 10 nF, C
X
= 5 pF; Ta = recommended range, unless otherwise noted
Vdd –0.5 V to +6.0 V
Max continuous pin current, any control or drive pin ±40 mA
Short circuit duration to ground, any pin infinite
Short circuit duration to Vdd, any pin infinite
Voltage forced onto any pin –0.6 V to (Vdd +0.6) V
CAUTION: Stresses beyond those listed under Absolute Maximum Specifications may cause permanent damage to
the device. This is a stress rating only and functional operation of the device at these or other conditions beyond those
indicated in the operational sections of this specification is not implied. Exposure to absolute maximum specification
conditions for extended periods may affect device reliability
Operating temp –40°C to +85°C
Storage temp –55°C to +125°C
Vdd +2.45 V to 5.5 V
Short-term supply ripple + noise ±5 mV p-p max
Long-term supply stability ±100 mV
C
S
value 10 nF to 500 nF
C
X
transverse load capacitance per channel 0 to 100 pF
Parameter Description Min Typ Max Units Notes
Idd Supply current – 1.0 2.5 mA
Vdds Supply turn-on slope 100 – – V/s
Required for proper
startup
Vil Low input logic level – – 0.2 × Vdd V OPT1, OPT2
Vhl High input logic level 0.9 × Vdd – – V OPT1, OPT2
Vol Low output voltage – – 0.6 V OUT, 4 mA sink
Voh High output voltage Vdd – 0.7 – – V OUT, 1 mA source
