NCS2003/A, NCV2003, NCS20032, NCV20032, NCS20034, NCV20034
www.onsemi.com
3
ABSOLUTE MAXIMUM RATINGS
Over operating free−air temperature, unless otherwise stated
Parameter Symbol Limit Unit
Supply Voltage (V
DD
− V
SS
) V
S
7.0 V
INPUT AND OUTPUT PINS
Input Voltage (Note 1)
V
IN
V
SS
− 0.3 to 7.0 V
Input Current I
IN
10 mA
Output Short Current (Note 2) I
O
100 mA
TEMPERATURE
Storage Temperature
T
STG
−65 to 150 °C
Junction Temperature T
J
150 °C
ESD RATINGS (Note 3)
Human Body Model NCx2003, A
NCx20032
NCx20034
HBM 3000
2000
3000
V
Machine Model NCx2003, A
NCx20032
NCx20034
MM 200
100
150
V
Charged Device Model NCx2003, A
NCx2003x
CDM 1000
2000
V
OTHER PARAMETERS
Moisture Sensitivity Level (Note 5)
MSL Level 1
Latch−up Current (Note 4) I
LU
100 mA
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. Neither input should exceed the range of V
SS
− 300 mV to 7.0 V. This device contains internal protection diodes between the input pins and
V
DD
. When V
IN
exceeds V
DD
, the input current should be limited to the specified value.
2. Indefinite duration; however, maximum package power dissipation limits must be observed to ensure that the maximum junction temperature
is not exceeded.
3. This device series incorporates ESD protection and is tested by the following methods:
ESD Human Body Model tested per AEC−Q100−002 and JESD22−A114
ESD Machine Model tested per AEC−Q100−003 and JESD22−A115
ESD Charged Device Model tested per AEC−Q100−011 and ANSI/ESD S5.3.1−2009
4. Latch−up current tested per JEDEC Standard JESD78.
5. Moisture Sensitivity Level tested per IPC/JEDEC standard J−STD−020A.
THERMAL INFORMATION
Thermal Metric Symbol Package Single Layer Board (Note 6) Multi Layer Board (Note 7) Unit
Junction to Ambient
Thermal Resistance
q
JA
SOT23−5/TSOP−5 408 355
°C/W
SOT553−5 428 406
Micro8/MSOP8 235 163
SOIC−8 240 179
TSSOP−8 300 238
SOIC−14 167 123
6. Values based on a 1S standard PCB according to JEDEC51−3 with 1.0 oz copper and a 300 mm
2
copper area
7. Values based on a 1S2P standard PCB according to JEDEC51−7 with 1.0 oz copper and a 100 mm
2
copper area
RECOMMENDED OPERATING CONDITIONS
Parameter Symbol Min Max Unit
Operating Supply Voltage (V
DD
− V
SS
) V
S
1.7 5.5 V
Specified Operating Range NCS2003, A
NCV2003, NCx20032, NCx20034
T
A
−40
−40
+85
+125
°C
Input Common Mode Range V
CM
V
SS
V
DD
−0.6 V
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
