PRODUCT SPECIFICATION
REVISION: ECR/ECN INFORMATION: TITLE:
PRODUCT SPECIFICATION FOR
MINI-FIT JR.
SHEET No.
E6
EC No:
UCP2013-2727
3 of 10
DATE:
2013/01/04
DOCUMENT NUMBER: CREATED / REVISED BY: CHECKED BY: APPROVED BY:
BBEE JBELL FSMITH
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC
4.0 RATINGS
4.1 VOLTAGE
600 Volts AC (RMS) (or 600 Volts DC)
4.2 APPLICABLE WIRES
Maximum Insulation Diameter
and
Applicable Wire Gauges
16 AWG: 3.10 mm / .122 inches MAXIMUM
18-24 AWG: 3.10 mm / .122 inches MAXIMUM
22-28 AWG: 1.80 mm / .071 inches MAXIMUM
4.3 MAXIMUM CURRENT RATING (Amperes)**
Note: PCB trace design may greatly affect temperature rise results in Wire-to-Board Applications.
** Ratings shown represent MAXIMUM current carrying capacity of a fully loaded connector with all circuits
powered. Ratings are based on a 30°C maximum temperature rise limit over ambient (room temperature).
Above charts are intended as a guideline. Current rating is application dependent. Appropriate de-rating is
required depending on factors such as higher ambient temperature, smaller copper weight of PCB traces,
gross heating from adjacent modules or components and other factors that influence connector
performance.
4.4 TEMPERATURE
Operating: * - 40°C to + 105°C
Nonoperating: - 40°C to + 105°C
*Including 30
°
C terminal temperature at rated current
4.5 WAVE SOLDER PROCESS TEMPERATURE
Headers with pegs: 240°C Maximum
Headers without pegs: 260°C Maximum
Table 3 - MAXIMUM CURRENT RATING (Amperes)
Wire-to-Wire and Wire-to-Board
Brass Phosphor Bronze
Ckt. Size
Wire
2 & 3 4 - 6 7 - 10
12 - 24
Ckt. Size
Wire
2 & 3 4 - 6 7 - 10 12 - 24
AWG #16 9 8 7 6 AWG #16 8 7 6 5
AWG #18 9 8 7 6 AWG #18 8 7 6 5
AWG #20 7 6 5 5 AWG #20 6 5 4 4
AWG #22 5 4 4 4 AWG #22 4 3 3 3
AWG #24 4 3 3 3 AWG #24 3 2 2 2
AWG #26 3 2 2 2 AWG #26 2 1 1 1
AWG #28 2 1 1 1 AWG #28 1 1 1 1