© Semiconductor Components Industries, LLC, 2011
March, 2011 − Rev. 3
1 Publication Order Number:
NCP1015/D
NCP1015
Self-Supplied Monolithic
Switcher for Low Standby-
Power Offline SMPS
The NCP1015 integrates a fixed−frequency current−mode
controller and a 700 V voltage MOSFET. Housed in a PDIP−7 or
SOT−223 package, the NCP1015 offers everything needed to build a
rugged and low−cost power supply, including soft−start, frequency
jittering, short−circuit protection, skip−cycle, a maximum peak
current set−point and a Dynamic Self−Supply (no need for an auxiliary
winding).
Unlike other monolithic solutions, the NCP1015 is quiet by nature:
during nominal load operation, the part switches at one of the available
frequencies (65−100 kHz). When the current set−point falls below a
given value, e.g. the output power demand diminishes, the IC
automatically enters the so−called skip cycle mode and provides
excellent efficiency at light loads. Because this occurs at typically 0.25
of the maximum peak value, no acoustic noise takes place. As a result,
standby power is reduced to the minimum without acoustic noise
generation.
Short−circuit detection takes place when the feedback signal fades
away e.g. un−true short−circuit or is broken optocoupler cases. Finally
soft−start and frequency jittering further ease the designer task to
quickly develop low−cost and robust offline power supplies.
For improved standby performance, the connection of an auxiliary
winding stops the DSS operation and helps to consume less than
100 mW at high line.
Features
• Built−in 700 V MOSFET with typical R
DS(on)
of 11 W
• Large Creepage Distance between High−voltage Pins
• Current−mode Fixed Frequency Operation: 65 kHz − 100 kHz
• Skip−cycle Operation at Low Peak Currents Only: No Acoustic Noise!
• Dynamic Self−Supply, No Need for an Auxiliary Winding
• Internal 1 ms Soft−start
• Auto−recovery Internal Output Short−circuit Protection
• Frequency Jittering for Better EMI Signature
• Below 100 mW Standby Power if Auxiliary Winding is Used
• Internal Temperature Shutdown
• Direct Optocoupler Connection
• SPICE Models Available for TRANsient and AC Analysis
• This is a Pb−Free Device
Typical Applications
• Low Power ac−dc Adapters for Chargers
• Auxiliary Power Supplies (USB, Appliances, TVs, etc.)
PDIP−7
CASE 626A
AP SUFFIX
1
8
MARKING
DIAGRAMS
P1015APyy
AWL
YYWWG
1
See detailed ordering and shipping information in the package
dimensions section on page 20 of this data sheet.
ORDERING INFORMATION
yy = 06 (65 kHz), 10 (100 kHz)
y = A (65 kHz), B (100 kHz)
A = Assembly Location
WL = Wafer Lot
YY = Year
WW = Work Week
G or G = Pb−Free Package
http://onsemi.com
PIN CONNECTIONS
1
V
CC
8
GND
2
NC
3
GND
4
FB
7
GND
5
DRAIN
(Top View)
SOT−223
CASE 318E
ST SUFFIX
1
4
AYW
1015y G
G
1
4
SOT−223
(Top View)
1
2
3
4
V
CC
FB
DRAIN
GND
PDIP−7
(*Note: Microdot may be in either location)
