14
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause catastrophic damage to the device. Limits apply to each parame-
ter in isolation, all other parameters having values within the recommended operating conditions. It should not be assumed that
limiting values of more than one parameter can be applied to the product at the same time. Exposure to the absolute maximum
ratings for extended periods can adversely aect device reliability.
Typical Operating Conditions
Process Compatibility
Notes:
1. The transceiver is class 1 eye safe up to V
CC
= 3.6 V.
2. Tested with a sinusoidal signal in the frequency range from 10 Hz to 1 MHz on the V
CC
supply with the recommended power supply lter in
place. Typically less than a 1 dB change in sensitivity is experienced.
3. Time delay from Transmit Disable Assertion to laser shutdown.
4. Time delay from Transmit Disable Deassertion to laser startup.
5. Aqueous wash pressure <110 psi.
Parameter Symbol Min Typ Max Unit Notes
Wave Soldering and Aqueous Wash T
SOLD
/t
SOLD
+260/10 °C/sec. 5
Parameter Symbol Min Typ Max Unit Notes
Storage Temperature (non-operating) T
S
-40 +85 °C
Relative Humidity RH 85 %
Supply Voltage V
CC
-0.5 3.6 V 1
Input Voltage on any Pin V
I
-0.5 V
CC
V
Parameter Symbol Min Typ Max Unit Notes
Case Operating Temperature T
C
-10 +25 +85 °C
Supply Voltage V
CC
3.1 3.3 3.5 V
Power Supply Noise Rejection PSNR 100 mV
P-P
2
Data Output Load R
DL
50
Ω
Transmit Disable Input Voltage - Low T
DIS
0.6 V
Transmit Disable Input Voltage - High T
DIS
2.2 V
Transmit Disable Assert Time T
assert
10 µs 3
Transmit Disable Deassert Time T
DEASSERT
1.0 ms 4
