24
SAM9M10 [SUMMARY]
6355ES–ATARM–12-Mar-13
7.1 Memory Mapping
A first level of address decoding is performed by the AHB Bus Matrix, i.e., the implementation of the Advanced High
performance Bus (AHB) for its Master and Slave interfaces with additional features.
Decoding breaks up the 4 Gbytes of address space into 16 banks of 256 Mbytes. The banks 1 to 6 are directed to the EBI
that associates these banks to the external chip selects NCS0 to NCS5.
The bank 7 is directed to the DDRSDRC0 that associates this bank to DDR_NCS chip select and so dedicated to the 4-
port DDR2/ LPDDR controller.
The bank 0 is reserved for the addressing of the internal memories, and a second level of decoding provides 1 Mbyte of
internal memory area. The bank 15 is reserved for the peripherals and provides access to the Advanced Peripheral Bus
(APB).
Other areas are unused and performing an access within them provides an abort to the master requesting such an
access.
7.2 Embedded Memories
7.2.1 Internal SRAM
The SAM9M10 product embeds a total of 64 Kbytes high-speed SRAM split in 4 blocks of 16 KBytes connected to one
slave of the matrix. After reset and until the Remap Command is performed, the four SRAM blocks are contiguous and
only accessible at address 0x00300000. After Remap, the SRAM also becomes available at address 0x0.
Figure 7-2. Internal SRAM Reset
The SAM9M10 device embeds two memory features. The processor Tightly Coupled Memory Interface (TCM) that
allows the processor to access the memory up to processor speed (PCK) and the interface on the AHB side allowing
masters to access the memory at AHB speed (MCK).
A wait state is necessary to access the TCM at 400 MHz. Setting the bit NWS_TCM in the bus Matrix TCM Configuration
Register of the matrix inserts a wait state on the ITCM and DTCM accesses.
7.2.2 TCM Interface
On the processor side, this Internal SRAM can be allocated to two areas.
z Internal SRAM A is the ARM926EJ-S Instruction TCM. The user can map this SRAM block anywhere in the
ARM926 instruction memory space using CP15 instructions and the TCR configuration register located in the Chip
Configuration User Interface. This SRAM block is also accessible by the ARM926 Masters and by the AHB
Masters through the AHB bus
z Internal SRAM B is the ARM926EJ-S Data TCM. The user can map this SRAM block anywhere in the ARM926
data memory space using CP15 instructions. This SRAM block is also accessible by the ARM926 Data Master and
by the AHB Masters through the AHB bus.
RAM
64K
0x00300000
RAM
64K
0x00000000
Remap
