XC18V00 Series In-System Programmable Configuration PROMs
14 www.xilinx.com DS026 (v3.9) November 18, 2002
1-800-255-7778 Product Specification
R
Absolute Maximum Ratings
(1,2)
Recommended Operating Conditions
Quality and Reliability Characteristics
DC Characteristics Over Operating Conditions
Symbol Description Value Units
V
CC
Supply voltage relative to GND –0.5 to +4.0 V
V
IN
Input voltage with respect to GND –0.5 to +5.5 V
V
TS
Voltage applied to High-Z output –0.5 to +5.5 V
T
STG
Storage temperature (ambient) –65 to +150 °C
T
SOL
Maximum soldering temperature (10s @ 1/16 in.) +260 °C
T
J
Junction temperature +150 °C
Notes:
1. Maximum DC undershoot below GND must be limited to either 0.5V or 10 mA, whichever is easier to achieve. During transitions, the
device pins can undershoot to –2.0V or overshoot to +7.0V, provided this over- or undershoot lasts less then 10 ns and with the
forcing current being limited to 200 mA.
2. Stresses beyond those listed under Absolute Maximum Ratings might cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other conditions beyond those listed under Operating Conditions
is not implied. Exposure to Absolute Maximum Ratings conditions for extended periods of time might affect device reliability.
Symbol Parameter Min Max Units
V
CCINT
Internal voltage supply (T
A
= 0°C to +70°C) Commercial 3.0 3.6 V
Internal voltage supply (T
A
= –40°C to +85°C) Industrial 3.0 3.6 V
V
CCO
Supply voltage for output drivers for 3.3V operation 3.0 3.6 V
Supply voltage for output drivers for 2.5V operation 2.3 2.7 V
V
IL
Low-level input voltage 0 0.8 V
V
IH
High-level input voltage 2.0 5.5 V
V
O
Output voltage 0 V
CCO
V
T
VCC
V
CC
rise time from 0V to nominal voltage
(1)
150ms
Notes:
1. At power up, the device requires the V
CC
power supply to monotonically rise from 0V to nominal voltage within the specified V
CC
rise
time. If the power supply cannot meet this requirement, then the device might not perform power-on-reset properly. See Figure 8.
Symbol Description Min Max Units
T
DR
Data retention 20 - Years
N
PE
Program/erase cycles (Endurance) 20,000 - Cycles
V
ESD
Electrostatic discharge (ESD) 2,000 - Volts
Symbol Parameter Test Conditions Min Max Units
V
OH
High-level output voltage for 3.3V outputs I
OH
= –4 mA 2.4 - V
High-level output voltage for 2.5V outputs I
OH
= –500 µA 90% V
CCO
-V
