OMO ElectronicOMO Electronic
Expand menu
Hello, Sign inMy Account
0 Cart

TR1001

P1-P3P4-P6P7-P9P10-P12
©2010-2014 by Murata Electronics N.A., Inc.
TR1001 (R) 10/16/14 Page 1 of 12
www.murata.com
RFM products are now
Murata products.
• Designed for Short-Range Wireless Data Communications
• Supports RF Data Transmission Rates Up to 115.2 kbps
• 3 V, Low Current Operation plus Sleep Mode
• Stable, Easy to Use, Low External Parts Count
• Complies with Directive 2002/95/EC (RoHS)
The TR1001 hybrid transceiver is ideal for short-range wireless data applications where robust operation,
small size, low power consumption and low cost are required. The TR1001 employs Murata’s amplifier-
sequenced hybrid (ASH) architecture to achieve this unique blend of characteristics. All critical RF functions
are contained in the hybrid, simplifying and speeding design-in. The receiver section of the TR1001 is
sensitive and stable. A wide dynamic range log detector, in combination with digital AGC and a compound
data slicer, provide robust performance in the presence of on-channel interference or noise. Two stages of
SAW filtering provide excellent receiver out-of-band rejection. The transmitter includes provisions for both on-
off keyed (OOK) and amplitude-shift keyed (ASK) modulation. The transmitter employs SAW filtering to
suppress output harmonics, facilitating compliance with ETSI I-ETS 300 220 and similar regulations.
Absolute Maximum Ratings
Rating Value Units
Power Supply and All Input/Output Pins -0.3 to +4.0 V
Non-Operating Case Temperature -50 to +100 °C
Soldering Temperature (10 seconds / 5 cycles max.) 260 °C
868.35 MHz
Hybrid
Transceiver
TR1001
SM-20H Case
Electrical Characteristics
Characteristic Sym Notes Minimum Typical Maximum Units
Operating Frequency
f
o
868.15 868.55 MHz
Modulation Types OOK & ASK
OOK Data Rate 30 kbps
ASK Data Rate 115.2 kbps
Receiver Performance, High Sensitivity Mode
Sensitivity, 2.4 kbps, 10-3 BER, AM Test Method 1 -106 dBm
Sensitivity, 2.4 kbps, 10-3 BER, Pulse Test Method 1 -100 dBm
Current, 2.4 kbps (R
PR
= 330 K)
23.0mA
Sensitivity, 19.2 kbps, 10-3 BER, AM Test Method 1 -101 dBm
Sensitivity, 19.2 kbps, 10-3 BER, Pulse Test Method 1 -95 dBm
Current, 19.2 kbps (R
PR
= 330 K)
23.1mA
Sensitivity, 115.2 kbps, 10-3 BER, AM Test Method 1 -97 dBm
Sensitivity, 115.2 kbps, 10-3 BER, Pulse Test Method 1 -91 dBm
Current, 115.2 kbps 3.8 mA
Receiver Performance, Low Current Mode
Sensitivity, 2.4 kbps, 10-3 BER, AM Test Method 1 -104 dBm
Sensitivity, 2.4 kbps, 10-3 BER, Pulse Test Method 1 -98 dBm
Current, 2.4 kbps (R
PR
= 1100 K)
21.8mA
Receiver Out-of-Band Rejection, ±5% fo
R
±5%
380dB
Receiver Ultimate Rejection
R
ULT
3 100 dB
©2010-2014 by Murata Electronics N.A., Inc.
TR1001 (R) 10/16/14 Page 2 of 12
www.murata.com
Dimension
mm Inches
Min Nom Max Min Nom Max
A 9.800 10.033 10.135 .388 .395 .400
B 6.650 6.858 6.985 .261 .270 .275
C 1.735 1.930 2.032 .068 .076 .080
D 1.645 1.778 1.905 .064 .070 .075
E 0.381 0.508 0.635 .015 .020 .025
F 0.889 1.016 1.143 .035 .040 .045
G 3.175 3.302 3.429 .125 .130 .135
H 1.360 1.524 1.651 .055 .060 .065
Electrical Characteristics (typical values given for 3.0 Vdc power supply, 25 °C)
Characteristic Sym Notes Minimum Typical Maximum Units
Transmitter Performance
Peak RF Output Power, 450 µA TXMOD Current
P
O
31.5dBm
Peak Current, 450 µA TXMOD Current
I
TP
312mA
2nd - 4th Harmonic Outputs 3 -50 dBm
5th - 10th Harmonic Outputs 3 -55 dBm
Non-harmonic Spurious Outputs 3 -50 dBm
OOK Turn On/Turn Off Times
t
ON
/t
OFF
4 12/6 µs
ASK Output Rise/Fall Times
t
TR
/t
TF
4 1.1/1.1 µs
Sleep Mode Current
I
S
0.7 µA
Power Supply Voltage Range
V
CC
2.2 3.7 Vdc
Power Supply Voltage Ripple 10
mV
P-P
Ambient Operating Temperature
T
A
-40 85 °C
1. Typical sensitivity data is based on a 10
-3
bit error rate (BER), using DC-balanced data. There are two test methods commonly used to measure OOK/ASK
receiver sensitivity, the “100% AM” test method and the “Pulse” test method. Sensitivity data is given for both test methods. See Appendix 3.8 in the ASH
Transceiver Designer’s Guide for the details of each test method, and for sensitivity curves for a 2.2 to 3.7 V supply voltage range at five operating
temperatures. The application/test circuit and component values are shown on the next page and in the Designer’s Guide.
2. At low data rates it is possible to adjust the ASH pulse generator to trade-off some receiver sensitivity for lower operating current. Sensitivity data and receiver
current are given at 2.4 kbps for both high sensitivity operation (R
PR
= 330 K) and low current operation (R
PR
= 1100 K).
3. Data is given with the ASH radio matched to a 50 ohm load. Matching component values are given on the next page.
4. See Table 1 on Page 8 for additional information on ASH radio event timing.
3
4
5
6
7
9
11
12
13
14
15
16
17
19
ASH Transceiver Pin Out
RFIO
8
2
10
201
18
LPFADJ
RREF
THLD2
AGCCAP
PKDET
BBOUT
CMPIN
RXDATA
TXMOD THLD1
PRATE
PWIDTH
GND1
VCC1
GND2
VCC2
GND3
CNTRL0
CNTRL1
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
S M - 2 0 H P a c k a g e D r a w i n g
*
)
+ ,
-
.
/
0
©2010-2014 by Murata Electronics N.A., Inc.
TR1001 (R) 10/16/14 Page 3 of 12
www.murata.com
Modulation Input
Data Output
TOP VIEW
GND
3
CNT
RL0
CNT
RL1
P
WIDTH
P
RATE
THLD
1
THLD
2
RREF
GND2
TX
MOD
RX
DATA
LPF
ADJ
CMP
IN
BB
OUT
PK
DET
AGC
CAP
VCC
1
VCC
2
RFIO
GND1
+ 3
VDC
ASH Transceiver Application Circuit
OOK Configuration
1
20
23456789
10
11
1213141516171819
+ 3
VDC
R
PW
R
PR
R
TH1
R
REF
R
LPF
R
TXM
C
BBO
C
RFB2
C
DCB
L
AT
L
ESD
C
RFB1
L
RFB
+
T/R
C
LPF
R
BBO
Modulation Input
Data Output
TOP VIEW
GND
3
CNT
RL0
CNT
RL1
P
WIDTH
P
RATE
THLD
1
THLD
2
RREF
GND2
TX
MOD
RX
DATA
LPF
ADJ
CMP
IN
BB
OUT
PK
DET
AGC
CAP
VCC
1
VCC
2
RFIO
GND1
+ 3
VDC
ASH Transceiver Application Circuit
ASK Configuration
1
20
23456789
10
11
1213141516171819
+ 3
VDC
TR Mode
Control
R
PW
R
PR
R
TH1
R
TH2
R
REF
R
LPF
R
TXM
C
BBO
C
PKD
C
AGC
C
RFB2
C
DCB
L
AT
L
ESD
C
RFB1
L
RFB
+
Tranceiver Set-Up, 3.0 Vdc, -40 to +85 °C
Item Symbol OOK OOK ASK Units Notes
Encoded Data Rate
DR
NOM
2.4 19.2 115.2 kbps see page 1& 2
Minimum Signal Pulse
SP
MIN
416.67 52.08 8.68 µs single bit
Maximum Signal Pulse
SP
MAX
1666.68 208.32 34.72 µs 4 bits of same value
AGCCAP Capacitor
C
AGC
- - 2200 pF ±10% ceramic
PKDET Capacitor
C
PKD
- - 0.001 µF ±10% ceramic
BBOUT Capacitor
C
BBO
0.1 0.015 0.0027 µF ±10% ceramic
BBOUT Resistor
R
BBO
12 0 0 K ±5%
LPFAUX Capacitor
C
LPF
0.0047 - - µF ±5%
TXMOD Resistor
R
TXM
4.7 4.7 4.7 K ±5%, for 1.5 dBm output
LPFADJ Resistor
R
LPF
330 100 15 K ±5%
RREF Resistor
R
REF
100 100 100 K ±1%
THLD2 Resistor
R
TH2
- - 100 K ±1%, for 6 dB below peak
THLD1 Resistor
R
TH1
0 0 10 K ±1%, typical values
PRATE Resistor
R
PR
330 330 160 K ±5%
PWIDTH Resistor
R
PW
270 to GND 270 to GND 1000 to Vcc K ±5%
DC Bypass Capacitor
C
DCB
4.7 4.7 4.7 µF tantalum
RF Bypass Capacitor 1
C
RFB1
27 27 27 pF ±5% NPO
RF Bypass Capacitor 2
C
RFB2
100 100 100 pF ±5% NPO
RF Bypass Bead
L
RFB
Fair-Rite Fair-Rite Fair-Rite vendor 2506033017YO or equivalent
Antenna Tuning Inductor
L
AT
10 10 10 nH 50 ohm antenna
Shunt Tuning/ESD Inductor
L
ESD
100 100 100 nH 50 ohm antenna
P1-P3P4-P6P7-P9P10-P12

TR1001

Mfr. #:
Buy TR1001
Manufacturer:
Murata Electronics
Description:
RF Receiver 2G ASH Transceiver 868.35MHz 115.2kbps
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet