DS1225AB/AD
2 of 9
READ MODE
The DS1225AB and DS1225AD execute a read cycle whenever
(Write Enable) is inactive (high) and
(Chip Enable) and
(Output Enable) are active (low). The unique address specified by the 13
address inputs (A
0
-A
12
) defines which of the 8192 bytes of data is to be accessed. Valid data will be
available to the eight data output drivers within t
ACC
(Access Time) after the last address input signal is
stable, providing that
and
access times are also satisfied. If
and
access times are not
satisfied, then data access must be measured from the later-occurring signal and the limiting parameter is
either t
CO
for
or t
OE
for
rather than address access.
WRITE MODE
The DS1225AB and DS1225AD execute a write cycle whenever the
and
signals are active
(low) after address inputs are stable. The later-occurring falling edge of
or
will determine the
start of the write cycle. The write cycle is terminated by the earlier rising edge of
or
. All address
inputs must be kept valid throughout the write cycle.
must return to the high state for a minimum
recovery time (t
WR
) before another cycle can be initiated. The
control signal should be kept inactive
(high) during write cycles to avoid bus contention. However, if the output drivers are enabled (
and
active) then
will disable the outputs in t
ODW
from its falling edge.
DATA RETENTION MODE
The DS1225AB provides full functional capability for V
CC
greater than 4.75 volts and write protects by
4.5 volts. The DS1225AD provides full-functional capability for V
CC
greater than 4.5 volts and write
protects by 4.25 volts. Data is maintained in the absence of V
CC
without any additional support circuitry.
The nonvolatile static RAMs constantly monitor V
CC
. Should the supply voltage decay, the NV SRAMs
automatically write protect themselves, all inputs become “don’t care,” and all outputs become high-
impedance. As V
CC
falls below approximately 3.0 volts, the power switching circuit connects the lithium
energy source to RAM to retain data. During power-up, when V
CC
rises above approximately 3.0 volts,
the power switching circuit connects external V
CC
to RAM and disconnects the lithium energy source.
Normal RAM operation can resume after V
CC
exceeds 4.75 volts for the DS1225AB and 4.5 volts for the
DS1225AD.
FRESHNESS SEAL
Each DS1225 is shipped from Maxim with the lithium energy source disconnected, guaranteeing full
energy capacity. When V
CC
is first applied at a level of greater than V
TP
, the lithium energy source is
enabled for battery backup operation.
