MTFDDAV480TBY-1AR16ABYY Datasheet MTFDDAV240TCB-1AR1ZABYY, MTFDDAK240TCB-1AR1ZABYY, MTFDDAK240TCB-1AR16ABYY | P7-P9

Logical Block Address Configuration

The drive is set to report the number of logical block addresses (LBAs) that will ensure

sufficient storage space for the specified capacity. Standard LBA settings, based on the

IDEMA standard (LBA1-03), are shown below.

Table 6: Standard LBA Settings – 512-Byte Sector Size

Capacity

Total LBA Max LBA

User Available

Bytes

Decimal Hexadecimal Decimal Hexadecimal (Unformatted)

240GB 468,862,128 1BF244B0 468,862,127 1BF244AF 240,057,409,536

480GB 937,703,088 37E436B0 937,703,087 37E436AF 480,103,981,056

960GB 1,875,385,008 6FC81AB0 1,875,385,007 6FC81AAF 960,197,124,096

1920GB 3,750,748,848 DF8FE2B0 3,750,748,847 DF8FE2AF 1,920,383,410,176

3840GB 7,501,476,528 1BF1F72B0 7,501,476,527 1BF1F72AF 3,840,755,982,336

7680GB 15,002,931,888 37E3E92B0 15,002,931,887 37E3E92AF 7,681,501,126,656

Reliability

Micron’s SSDs incorporate advanced technology for defect and error management.

They use various combinations of hardware-based error correction algorithms and

firmware-based static and dynamic wear-leveling algorithms.

Over the life of the SSD, uncorrectable errors may occur. An uncorrectable error is de-

fined as data that is reported as successfully programmed to the SSD but when it is read

out of the SSD, the data differs from what was programmed.

Table 7: Uncorrectable Bit Error Rate

Uncorrectable Bit Error Rate Operation

<1 sector per 10

bits READ

Mean Time to Failure

Mean time to failure (MTTF) for the SSD can be predicted based on the component reli-

ability data using the methods referenced in the Telcordia SR-332 reliability prediction

procedures for electronic equipment.

Table 8: MTTF

Capacity MTTF (Operating Hours)

All capacities 3.0 million

Note:

1. The product achieves a MTTF of 3.0 million hours based on population statistics not rele-

vant to individual units.

5100 Series NAND Flash SSD

Logical Block Address Configuration

CCMTD-1725822587-10309

5100_series_SSD_disti.pdf - Rev. C 08/17 EN

Micron Technology, Inc. reserves the right to change products or specifications without notice.

Endurance

Endurance for the SSD can be predicted based on the usage conditions applied to the

device, the internal NAND component cycles, the write amplification factor, and the

wear-leveling efficiency of the drive. Total bytes written measured with 55°C case tem-

perature within the total bytes written values listed in this document. The table below

shows the drive lifetime for each SSD capacity based on predefined usage conditions.

Table 9: Drive Lifetime

Capacity

Drive Lifetime (Total Bytes Written)

UnitECO PRO MAX

240GB – 650 2,200 TB

480GB 450 1,300 4,400

960GB 900 4,400 8,800

1920GB 3,200 8,800 17,600

3840GB 6,400 17,600 –

7680GB 8,400 – –

Notes:

1. Total bytes written were calculated assuming drive is 100% full (user capacity) and a

workload of 100% random, aligned 4KB writes.

2. 1TB = 1,000,000,000,000 bytes

5100 Series NAND Flash SSD

Reliability

CCMTD-1725822587-10309

5100_series_SSD_disti.pdf - Rev. C 08/17 EN

Micron Technology, Inc. reserves the right to change products or specifications without notice.

Electrical Characteristics

Stresses greater than those listed may cause permanent damage to the device. This is a

stress rating only, and functional operation of the device at these or any other condi-

tions above those indicated in the operational sections of this specification is not im-

plied. Exposure to absolute maximum rating conditions for extended periods may affect

reliability.

Table 10: SATA Power Consumption – 2.5-inch

Capacity Idle Average

Sequential Write

(128KB transfer)

Sequential Read

(128KB transfer)

240GB 1.5W <4.5W <4.5W

480GB 1.5W <4.5W <4.5W

960GB 1.5W 5W 5W

1920GB 1.5W <5.5W <5.5W

3840GB 1.5W <6W <6W

7680GB 1.5W 6W 6W

Notes:

1. Data taken at 25°C using a 6 Gb/s SATA interface.

2. Sequential power measured during Iometer with 128KB transfer, RMS average over a

500ms window.

Table 11: SATA Power Consumption – M.2 Type 2280

Capacity Idle Average

Sequential Write

(128KB transfer)

Sequential Read

(128KB transfer)

240GB 1.5W <4.5W <4.5W

480GB 1.5W <4.5W <4.5W

960GB 1.5W <5W <5W

1920GB 1.5W 5W 5W

Notes:

1. Data taken at 25°C using a 6 Gb/s SATA interface.

2. Sequential power measured during Iometer with 128KB transfer, RMS average over a

500ms window.

5100 Series NAND Flash SSD

Electrical Characteristics

CCMTD-1725822587-10309

5100_series_SSD_disti.pdf - Rev. C 08/17 EN

Micron Technology, Inc. reserves the right to change products or specifications without notice.

P1-P3 P4-P6 P7-P9 P10-P12 P13-P15 P16-P18 P19-P21 P22-P24 P25-P27 P28-P30 P31-P33 P34-P34

MTFDDAV480TBY-1AR16ABYY

Mfr. #:

Buy MTFDDAV480TBY-1AR16ABYY

Manufacturer:

Micron

Description:

Solid State Drives - SSD 5100 480GB M.2 SSD

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

MTFDDAV480TBY-1AR16ABYY

MTFDDAV480TBY-1AR16ABYY

Products related to this Datasheet