TDA3683_2 © Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet Rev. 02 — 7 October 2005 25 of 31
Philips Semiconductors
TDA3683
Multiple voltage regulator with switch and ignition buffer
• The output voltage of regulator 7 can be adjusted between 2.4 V and 10 V using two
external resistors (R1 and R2); see Figure 10. The following equation can be used for
global calculations to determine the output voltage at a given value of R1 and R2:
To meet an overall accuracy of 5 % the external resistors should have a 1 % tolerance
and the total resistance of the external resistors should have a value maximum 2 kΩ.
In the event that no external resistors are used the output voltage will be determined only
by the internal feedback resistors. The output voltage will be as follows: V
o
= 10 V (±5 %).
Table 8: ESR restrictions
Output of regulator Maximum ESR
Regulator 1 3 Ω
Regulator 2 3 Ω
Regulator 3 6 Ω
Regulator 4 20 Ω
Regulator 5 6 Ω
Regulator 6 14 Ω
Regulator 7 10 Ω
Fig 10. Application diagram for REG7
V
REG7
1.2 1
R1
R2
-------
+
×=
R1
(1 %)
R2
(1 %)
001aac136
1.2 V REG7
ADJ7
TDA3683