AXL F DO8/2 2A 1H
8238_en_04 PHOENIX CONTACT 5 / 14
Nominal load, ohmic max. 48 W (12 Ω, at nominal load)
Nominal load, inductive max. 48 VA (1.2 H, 12 Ω, at nominal load)
Nominal load, lamp max. 48 W (at nominal voltage)
Signal delay max. 150 µs (when switched on)
max. 150 µs (When switched off; with at least 100mA load current)
Switching frequency max. 3000 per second (with ohmic load)
Switching frequency max. 1 per second (with inductive load)
Switching frequency max. 4 per second (with nominal lamp load)
Load min. 10 kΩ
Energy consumption see diagram
Derating For channel groups 1 ... 4 and 5 ... 8: 8A to30°C, then dropping linearly to 6A
at60°C
Derating diagram for channel groups 1 ... 4 and 5 ... 8
Output voltage when switched off max. 1 V
Output current when switched off max. 300 µA
Behavior with overload Shutdown with automatic restart
Behavior with inductive overload Output can be destroyed
Reverse voltage resistance to short pulses Limited protection up to 0.5 A for 1 s
NOTE: Damage to the electronics
If there is a faulty external voltage (reverse voltage) at one of the outputs, the output may be destroyed. This may cause unintentional setting
of further outputs.
Overcurrent shut-down as of 2.8 A
Output current with ground connection interrupt when switched off < 1 mA
Short-circuit protection, overload protection of the outputs Electronic
Derating For channel groups 1 ... 4 and 5 ... 8: 8A to30°C, then dropping linearly to 6A
at60°C
Digital outputs
I [A]
0
T [°C]
2
4
6
8
0
10 20 30 40 50 60
Configuration and parameter data in a PROFIBUS system
Required parameter data 1 Byte
Need for configuration data 6 Byte
Error messages to the higher level control or computer system
Short-circuit / overload of the digital outputs Yes
Electrical isolation/isolation of the voltage areas
Test section Te s t vo l t a g e
5 V communications power (logic), 24 V supply (I/O) 500 V AC, 50 Hz, 1 min.
5 V supply (logic)/functional earth ground 500 V AC, 50 Hz, 1 min.
24 V supply (I/O) / functional earth ground 500 V AC, 50 Hz, 1 min.
Mechanical tests
Vibration resistance in acc. with EN60068-2-6/IEC60068-2-6 5g
Shock in acc. with EN60068-2-27/IEC60068-2-27 30g
Continuous shock according to EN60068-2-27/IEC60068-2-27 10g
