FL-PP-RJ45... / FL CAT5...
104622_en_04 PHOENIX CONTACT 7
6 Patch panel FL-PP-RJ45-SCC with spring-cage connection terminal blocks
6.1 Design
1 RJ45 socket (TP port)
2 Spring-cage connection terminal blocks for field cabling
3 Strain relief with shield connection
4 Jumper for selecting shield grounding
5 Universal snap-on foot for DIN rails
6 DIN rail
6.2 Dimensions
Figure 1 Dimensions of FL-PP-RJ45-SCC
6.3 Connecting the Ethernet network
Twisted pair interface (TP port)
• Take the Ethernet patch cable which leads to the termi-
nation device and has a RJ45 connector, and push this
into the RJ45 socket (TP port) until the connector audi-
bly snaps in.
Pin assignment and color coding
Figure 2 Ethernet (IEC 80.3u: TIA 568 A, TIA 568 B)
and PROFINET
– YE = yellow
–OG = orange
–WH = white
–BU = blue
– GN = green
–BN = brown
Spring-cage connection terminal blocks
Figure 3 Required stripping lengths
– a = 10 mm
–b = 40 mm
–c = 8 mm
• Remove cable sheath in accordance with length B.
• Fold back 10 mm of the braided shield over the outer
sheath.
• Remove the aluminum foil.
• Shorten wires 4, 5, 7, and 8 by 10 mm as required for
the lower terminal block.
• Strip 8 mm off each single wire.
• Lay the shielding under the clip bracket of the strain re-
lief and screw tight.
• Connect all single wires to the spring-cage connection
terminal blocks. If possible, make sure the single wires
remain twisted up to the connection terminal blocks.
Only use shielded twisted pair cables and corre-
sponding shielded RJ45 connectors.
3
4
1
2
5
6
12 3 6
4
578
1
Ø
89,6
59,8
52,3
29
12 36
4
5 7 8
BU6
WH3
OG2
YE1
1236
WH/BN7
GN6
BU4
WH/BU5
BN8
WH/GN3
OG2
WH/OG1
12364578
TIA 568 A
WH/BN7
OG6
BU4
WH/BU5
BN8
WH/OG3
GN2
WH/GN1
12364578
Ethernet
TIA 568 B
PROFINET
