IDT1337G
REAL-TIME CLOCK WITH I
2
C SERIAL INTERFACE RTC
IDT®
REAL-TIME CLOCK WITH I
2
C SERIAL INTERFACE 13
IDT1337G REV M 073013
Handling, PCB Layout, and Assembly
The IDT1337G package contains a quartz tuning-fork crystal. Pick-and-place equipment may be used, but precautions
should be taken to ensure that excessive shocks are avioded. Ultrasonic cleaning equipment should be avioded to prevent
damage to the crystal.
Avoid running signal traces under the package, unless a ground plane is placed between the package and the signal line.
All NC (no connect) pins must be connected to ground.
Moisture-sensitive packages are shipped from the factory dry-packed. Handling instructions listed on the package label must
be followed to prevent damage during reflow. Refer to the IPC/JEDEC J-STD-020 standard for moisture-sensitive device
(MSD) classifications.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the IDT1337G. These ratings, which are standard
values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these or any other
conditions above those indicated in the operational sections of the specifications is not implied. Exposure to absolute
maximum rating conditions for extended periods can affect product reliability. Electrical parameters are guaranteed only
over the recommended operating temperature range.
Recommended DC Operating Conditions
Item Rating
Voltage Range (on any pin relative to ground) -0.3 V to +6.0 V
Storage Temperature -55 to +125C
Soldering Temperature 260C
Ambient Operating Temperature (industrial) -40 to +85°C
Parameter Symbol Conditions Min. Typ. Max. Units
VCC Supply Voltage V
CC
Full operation 1.8 3.3 5.5 V
V
CCT
Timekeeping 1.3 1.8 V
Ambient Operating Temperature (industrial) T
A
-40 +85 C
Logic 1 V
IH
SCL, SDA 0.8VCC VCC + 0.3 V
INTA
, SQW/INTB 5.5
Logic 0 V
IL
-0.3 +0.3VCC V
