25
FN8208.2
September 7, 2010
V
TRIPX
(X = 1,2) PROGRAMMING PARAMETERS (See Figure 24)
Notes: These parameters are not 100% tested.
V2RO, V3RO OUTPUT TIMING. (See Figure 23)
Notes: 1. See Figure 23 for timing diagram.
Notes: 2.See Figure 18 for equivalent load.
Notes: 3.This parameter describes the lowest possible Vcc / V1 level for which the outputs V2RO, and V3RO will be correct with respect to their
inputs ( V2, V3).
Notes: 4.The above parameters are not 100% tested.
Parameter Description Min Typ Max Units
t
VPS
V
TRIPx
Program Enable Voltage Setup time
10 μs
t
VPH
V
TRIPx
Program Enable Voltage Hold time
10 μs
t
TSU
V
TRIPx
Setup time
10 μs
t
THD
V
TRIPx
Hold (stable) time
10 μs
t
VPO
V
TRIPx
Program Enable Voltage Off time
(Between successive adjustments)
1ms
t
wc
V
TRIPx
Write Cycle time
510 ms
V
P
Programming Voltage 10 15 V
V
ta
V
TRIPx
Program Voltage accuracy
(Programmed at 25
°
C.)
-100 +100 mV
V
tv
V
TRIP
Program variation after programming (-40 - 85
°
C).
(Programmed at 25
°
C.)
-25 +10 +25 mV
Symbol Description Condition Min. Typ. Max. Units
t
RPDx
(4)
V2, V3 to V2RO, V3RO propagation
delay (respectively)
20 μs
t
Fx
(4)
V2, V3 Fall Time 20 mV/μs
t
Rx
(4)
V2, V3 Rise Time 20 mV/μs
V
RVALID
(4)
Vcc / V1 for V2RO, V3RO Valid
(3)
.
1V
X9522