FEBRUARY 8, 2017 5 2-OUTPUT 3.3V PCIE ZERO-DELAY BUFFER
9DBL0242 / 9DBL0252 DATASHEET
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the 9DBL0242 / 9DBL0252. These ratings, which are
standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these or any other
conditions above those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods can affect product reliability. Electrical parameters are guaranteed only over the
recommended operating temperature range.
Electrical Characteristics–Clock Input Parameters
Electrical Characteristics–SMBus Parameters
PARAMETER SYMBOL CONDITIONS
MIN TYP MAX
UNITS NOTES
Supply Voltage VDDx 4.6 V 1,2
Input Voltage V
IN
DD
+0.5 V 1,3
Input High Voltage, SMBus V
IHSMB
SMBus clock and data pins 3.9 V 1
Storage Temperature Ts -65 150 °C 1
Junction Temperature Tj 125 °C 1
Input ESD protection
ESD prot Human Body Model 2500 V 1
1
Guaranteed by design and characterization, not 100% tested in production.
2
Operation under these conditions is neither implied nor guaranteed.
3
Not to exceed 4.6V.
TA = T
AMB,
Supply Voltages per normal operation conditions, See Test Loads for Loading Conditions
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS NOTES
Input Crossover Voltage -
DIF_IN
V
CROSS
Cross Over Voltage 150 900 mV 1
Input Swing - DIF_IN V
SWING
Differential value 300 mV 1
Input Slew Rate - DIF_IN dv/dt Measured differentially 0.4 8 V/ns 1,2
Input Leakage Current I
IN
IN
DD ,
IN
GND -5 5 uA
Input Duty Cycle d
tin
Measurement from differential wavefrom 45 55 % 1
Input Jitter - Cycle to Cycle J
DIFIn
Differential Measurement 0 125 ps 1
1
Guaranteed by design and characterization, not 100% tested in production.
2
Slew rate measured through +/-75mV window centered around differential zero
TA = T
AMB;
Supply Voltages per normal operation conditions, See Test Loads for Loading Conditions
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS NOTES
SMBus Input Low Voltage V
ILSMB
DDSMB
= 3.3V 0.8 V
SMBus Input High Voltage V
IHSMB
DDSMB
= 3.3V 2.1 3.6 V
SMBus Output Low Voltage V
OLSMB
PULLUP
0.4 V
SMBus Sink Current I
PULLUP
OL
4mA
Nominal Bus Voltage V
DDSMB
2.7 3.6 V
SCLK/SDATA Rise Time t
RSMB
(Max VIL - 0.15) to (Min VIH + 0.15) 1000 ns 1
SCLK/SDATA Fall Time t
FSMB
(Min VIH + 0.15) to (Max VIL - 0.15) 300 ns 1
SMBus Operating
Frequency
f
SMB
SMBus operating frequency 500 kHz 2,3
1
Guaranteed by design and characterization, not 100% tested in production.
2.
The device must be powered up for the SMBus to function.
3.
The differential input clock must be running for the SMBus to be active