4
LTC3819
3819f
ELECTRICAL CHARACTERISTICS
The ● denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T
A
= 25°C. V
IN
= 15V, V
BIAS
= 5V, V
RUN/SS
= 5V unless otherwise noted.
Note 5: Dynamic supply current is higher due to the gate charge being
delivered at the switching frequency. See Applications Information.
Note 6: Rise and fall times are measured using 10% and 90% levels. Delay
times are measured using 50% levels.
Note 7: The minimum on-time condition corresponds to the on inductor
peak-to-peak ripple current ≥40% I
MAX
(see Minimum On-Time
Considerations in the Applications Information section).
Note 8: Each built-in pull-up resistor attached to the VID inputs also has a
series diode to allow input voltages higher than the VIDV
CC
supply without
damage or clamping (see the Applications Information section).
Note 1: Absolute Maximum Ratings are those values beyond which the
life of a device may be impaired.
Note 2: The LTC3819EG is guaranteed to meet performance specifications
from 0°C to 70°C. Specifications over the –40°C to 85°C operating
temperature range are assured by design, characterization and correlation
with statistical process controls.
Note 3: T
J
is calculated from the ambient temperature T
A
and power
dissipation P
D
according to the following formula:
LTC3819EG: T
J
= T
A
+ (P
D
• 85°C/W)
Note 4: The LTC3819 is tested in a feedback loop that servos V
ITH
to a
specified voltage and measures the resultant V
EAIN
.
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
Oscillator and Phase-Locked Loop
f
NOM
Nominal Frequency V
PLLFLTR
= 1.2V 190 220 250 kHz
f
LOW
Lowest Frequency V
PLLFLTR
= 0V 120 140 160 kHz
f
HIGH
Highest Frequency V
PLLFLTR
≥ 2.4V 280 310 360 kHz
R
PLLIN
PLLIN
Input Resistance 50 kΩ
I
PLLFLTR
Phase Detector Output Current
Sinking Capability f
PLLIN
< f
OSC
–15 µA
Sourcing Capability f
PLLIN
> f
OSC
15 µA
R
RELPHS
Controller 2-Controller 1 Phase 180 Deg
PGOOD Output
V
PGL
PGOOD Voltage Low I
PGOOD
= 2mA 0.1 0.3 V
I
PGOOD
PGOOD Leakage Current V
PGOOD
= 5V ±1 µA
V
PG
PGOOD Trip Level, Either Controller V
EAIN
with Respect to Set Output Voltage
V
EAIN
Ramping Negative –8 – 10 – 12 %
V
EAIN
Ramping Positive 8 10 12 %
Differential Amplifier/Op Amp Gain Block
A
DA
Differential Amplifier Gain V
AMPMD
= 0V 0.995 1 1.005 V/V
CMRR
DA
Common Mode Rejection Ratio 0V < V
CM
< 5V; V
AMPMD
= 0V 46 55 dB
R
IN
Input Resistance Measured at V
OS
+ Input; V
AMPMD
= 0V 80 kΩ
