LTC4267-1
8
42671fa
For more information www.linear.com/4267-1
pin FuncTions
PGND (Pin 1, 8, 9, 16): Switching Regulator Negative
Supply. This pin is the negative supply rail for the switching
regulator controller and must be tied to P
OUT
.
I
TH
/RUN (Pin 2): Current Threshold/Run Input. This pin
performs two functions. It serves as the switching regula-
tor error amplifier compensation point as well as the run/
shutdown control input. Nominal voltage range is 0.7V to
1.9V. Forcing the pin below 0.28V with respect to PGND
causes the controller to shut down.
NGATE (Pin 3): Gate Driver Output. This pin drives the
regulator’s external N-Channel MOSFET and swings from
PGND to P
VCC
.
P
VCC
(Pin 4): Switching Regulator Positive Supply. This
pin is the positive supply rail for the switching regulator
and must be closely decoupled to PGND.
R
CLASS
(Pin 5): Class Select Input. Used to set the current
value the PD maintains during classification. Connect a
resistor between R
CLASS
and V
PORTN
(see Table 2).
NC (Pin 6): No Internal Connection.
V
PORTN
(Pin 7): Negative Power Input. Tie to the –48V
input port through the input diodes.
P
OUT
(Pin 10): Power Output. Supplies –48V to the switch-
ing regulator PGND pin and any additional PD loads through
an
internal power
MOSFET that limits input current. P
OUT
is high impedance until the voltage reaches the turn-on
UVLO threshold. The output is then current limited. See
the Application Information section.
PWRGD (Pin 11): Power Good Output, Open-Drain.
Indicates that the PD MOSFET is on and the switching
regulator can start operation. Low impedance indicates
power is good. PWRD is high impedance during detec-
tion, classification and in the event of a thermal overload.
PWRD is referenced to V
PORTN
.
SIGDISA (Pin 12): Signature Disable Input. SIGDISA al-
lows the PD to present an invalid signature resistance and
remain inactive. Connecting SIGDISA to V
PORTP
lowers
the signature resistance to an invalid value and disables
all functions of the LTC4267-1. If unused, tie SIGDISA
to V
PORTN
.
V
PORTP
(Pin 13): Positive Power Input. Tie to the input
port power return through the input diodes.
SENSE (Pin 14): Current Sense. This pin performs two
functions. It monitors the regulator switch current by read-
ing the voltage across an external sense resistor. It also
injects a current ramp that develops a slope compensation
voltage across an optional external programming resistor.
See the Applications Information section.
V
FB
(Pin 15): Feedback Input. Receives the feedback volt-
age from the external resistor divider across the output.
(DFN/MSOP)
