2–20 Altera Corporation
Cyclone III FPGA Starter Board Reference Manual April 2012
Statement of China-RoHS Compliance
f You can measure the core and I/O voltage with a current meter while the
Cyclone III device is in standby mode. For more information on this
circuit, refer to the Cyclone III FPGA Starter Kit User Guide.
Statement
of China-RoHS
Compliance
Table 2–18 lists hazardous substances included with the kit.
3.30 100 2.0 JP5 REG3 LT1959CS8 I/O voltage and power for most
components including HSMC
12.00 200 1.0 SW1N/A N/A Inpu t supply voltage. All other
voltages (including HSMC voltage)
are derive from this regulator.
Note to Table 2–17:
(1) A 0.01 current sense resistor is added to select jumper points for FPGA core power and I/O power measurement.
Table 2–17. Board Regulators
Output
Voltage
(V)
Variance
(+/- mV)
MAX
Current
(A)
Board
Access
Point
Regulator
Board
Reference
Linear
Technologies
Part #
Where Used
Table 2–18. Table of Hazardous Substances’ Name and Concentration, Notes (1),(2)
Part Name
Lead
(Pb)
Cadmium
(Cd)
Hexavalent
Chromium
(Cr6+)
Mercury
(Hg)
Polybrominated
biphenyls (PBB)
Polybrominated
diphenyl Ethers
(PBDE)
Cyclone III
FPGA starter
board
X* 0 0 0 0 0
12-V power
supply
00 0 0 0 0
Type A-B
USB cable
00 0 0 0 0
User guide 0 0 0 0 0 0
Notes to Table 2–18:
(1) 0 indicates that the concentration of the hazardous substance in all homogeneous materials in the parts is below
the relevant threshold of the SJ/T11363-2006 standard.
(2) X* indicates that the concentration of the hazardous substance of at least one of all homogeneous materials in the
parts is above the relevant threshold of the SJ/T11363-2006 standard, but it is exempted by EU RoHS.
