1. General description
The NX3L1T53 is a low-ohmic single-pole double-throw analog switch suitable for use as
an analog or digital 2:1 multiplexer/demultiplexer. It has a digital select input (S), two
independent inputs/outputs (Y0 and Y1), a common input/output (Z) and an active LOW
enable input (E
). When pin E is HIGH, the switch is turned off.
Schmitt trigger action at the digital inputs makes the circuit tolerant to slower input rise and
fall times. Low threshold digital inputs allows this device to be driven by 1.8 V logic levels
in 3.3 V applications without significant increase in supply current I
CC
. This makes it
possible for the NX3L1T53 to switch 4.3 V signals with a 1.8 V digital controller,
eliminating the need for logic level translation. The NX3L1T53 allows signals with
amplitude up to V
CC
to be transmitted from Z to Y0 or Y1; or from Y0 or Y1 to Z. It’s low
ON resistance (0.5 ) and flatness (0.13 ) ensures minimal attenuation and distortion of
transmitted signals.
2. Features and benefits
Wide supply voltage range from 1.4 V to 4.3 V
Very low ON resistance (peak):
1.6 (typical) at V
CC
=1.4V
1.0 (typical) at V
CC
=1.65V
0.55 (typical) at V
CC
=2.3V
0.50 (typical) at V
CC
=2.7V
0.50 (typical) at V
CC
=4.3V
Break-before-make switching
High noise immunity
ESD protection:
HBM JESD22-A114F Class 3A exceeds 7500 V
MM JESD22-A115-A exceeds 200 V
CDM AEC-Q100-011 revision B exceeds 1000 V
IEC61000-4-2 contact discharge exceeds 8000 V for switch ports
CMOS low-power consumption
Latch-up performance exceeds 100 mA per JESD 78 Class II Level A
1.8 V control logic at V
CC
= 3.6 V
Control input accepts voltages above supply voltage
Very low supply current, even when input is below V
CC
High current handling capability (350 mA continuous current under 3.3 V supply)
Specified from 40 C to +85 C and from 40 C to +125 C
NX3L1T53
Low-ohmic single-pole double-throw analog switch
Rev. 8 — 23 January 2013 Product data sheet
