OMO ElectronicOMO Electronic
Expand menu
Hello, Sign inMy Account
0 Cart

MTA18ASF1G72PF1Z-2G1T12AB

P1-P3P4-P6P7-P9P10-P12P13-P15P16-P18P19-P21P22-P24
NVDIMM Power
To provide NVDIMM functionality requires certain NVDIMM controller logic to operate
at all times. The operation of this logic consumes power as described below.
Table 15: DDR4 NVDIMM Power – 8GB
NVDIMM Mode Power (typical) Units Notes
Normal host operation 1.2 Watts 1
SAVE operation 3.2 Watts 2
Notes:
1. This is the NVDIMM power over/above that consumed by DRAM (as reflected by the I
DD
parameters shown in the previous section), the power consumed by the register (RCD),
and the power supplied for DRAM I/O functionality.
2. This is the total power consumed by all components on the NVDIMM during a SAVE.
This power may be sourced from the PowerGEM attached to J3, or from another persis-
tent power source via the 12V pins on the NVDIMM edge connector.
8GB (x72, ECC, SR) 288-Pin DDR4 Nonvolatile RDIMM
I
DD
Specifications
PDF: 09005aef85c5dc9c
asf18c1gx72pf1z.pdf - Rev. C 03/16 EN
22
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2014 Micron Technology, Inc. All rights reserved.
Registering Clock Driver Specifications
Table 16: Registering Clock Driver Electrical Characteristics
DDR4 RCD01 devices or equivalent
Parameter Symbol Pins Min Nom Max Units
DC supply voltage V
DD
– 1.14 1.2 1.26 V
DC reference voltage V
REF
V
REFCA
0.49 × V
DD
0.5 × V
DD
0.51 × V
DD
V
DC termination
voltage
V
TT
– V
REF
- 40mV V
REF
V
REF
+ 40mV V
High-level input
voltage
V
IH. CMOS
DRST_n 0.65 × V
DD
– V
DD
V
Low-level input
voltage
V
IL. CMOS
0 – 0.35 × V
DD
V
DRST_n pulse width
t
IN-
IT_Pow-
er_stable
– 1.0 – – µs
AC high-level output
voltage
V
OH(AC)
All outputs except
ALERT_n
V
TT
+ (0.15 × V
DD
) – – V
AC low-level output
voltage
V
OL(AC)
– – V
TT
+ (0.15 x V
DD
) V
AC differential out-
put high measure-
ment level (for out-
put slew rate)
V
OHdiff(AC)
Yn_t - Yn_c, BCK_t -
BCK_c
– 0.3 × V
DD
– mV
AC differential out-
put low measure-
ment level (for out-
put slew rate)
V
OLdiff(AC)
– –0.3 × V
DD
– mV
Note:
1. Timing and switching specifications for the register listed are critical for proper opera-
tion of DDR4 SDRAM RDIMMs. These are meant to be a subset of the parameters for the
specific device used on the module. See the JEDEC RCD01 specification for complete op-
erating electrical characteristics. Registering clock driver parametric values are specified
for device default control word settings, unless otherwise stated. The RC0A control
word setting does not affect parametric values.
8GB (x72, ECC, SR) 288-Pin DDR4 Nonvolatile RDIMM
Registering Clock Driver Specifications
PDF: 09005aef85c5dc9c
asf18c1gx72pf1z.pdf - Rev. C 03/16 EN
23
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2014 Micron Technology, Inc. All rights reserved.
Module Dimensions
Figure 4: 288-Pin DDR4 NVDIMM
PCB
0
/
00
Front view
Back view
3.77
0.148in
(MAX)
2.20
0.087in
(2 PLCS)
1.27 ±0.10
0.050in ±0.004
(PCB THK)
2.50
0.098in
(MIN)
(component
area)
(both sides)
17.60 (MIN)
0.693in
(component area)
(both sides)
(2 PLCS)
2.80
0.110in
(MIN)
(component area)
(both sides)
2.80
0.110in
(MIN)
(component area)
(both sides)
2.50 (MIN)
0.098in
(component area)
(both sides)
5.575
0.2195in
Pin 1
Pin 144
Pin 145
Pin 288
133.35 ±0.15
5.250in ±0.006
31.25 ±0.15
1.230in ±0.006
0.75
0.030in
(8 PLCS)
4.00
0.057in
(MIN)
(component
area)
1.45 (MIN)
0.057in
(flat surface)
(4 PLCS)
14.60
0.575in
(2 PLCS)
17.60
0.693in
(2 PLCS)
11.00
0.433in
(2 PLCS)
0.50
0.020in
(2 PLCS)
8.00
0.315in
(2 PLCS)
RAD THRU
0.45
0.018in
X 45.0°
CHAMFER
(2 PLCS)
1.25
0.049in
X 45.0°
CHAMFER
(2 PLCS)
1.45
0.057in
(MIN)
(flat surface)
(4 PLCS)
1.20
0.047in
(MAX)
1.20
0.047in
(MAX)
2.15
0.085in
(MAX)
6.24
0.246in
(MAX)
Notes:
1. All dimensions are in millimeters (inches); MAX/MIN or typical (TYP) where noted.
2. The dimensional diagram is for reference only.
8000 S. Federal Way, P.O. Box 6, Boise, ID 83707-0006, Tel: 208-368-4000
www.micron.com/products/support Sales inquiries: 800-932-4992
Micron and the Micron logo are trademarks of Micron Technology, Inc.
All other trademarks are the property of their respective owners.
This data sheet contains minimum and maximum limits specified over the power supply and temperature range set forth herein.
Although considered final, these specifications are subject to change, as further product development and data characterization some-
times occur.
8GB (x72, ECC, SR) 288-Pin DDR4 Nonvolatile RDIMM
Module Dimensions
PDF: 09005aef85c5dc9c
asf18c1gx72pf1z.pdf - Rev. C 03/16 EN
24
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2014 Micron Technology, Inc. All rights reserved.
P1-P3P4-P6P7-P9P10-P12P13-P15P16-P18P19-P21P22-P24

MTA18ASF1G72PF1Z-2G1T12AB

Mfr. #:
Buy MTA18ASF1G72PF1Z-2G1T12AB
Manufacturer:
Micron
Description:
MODULE DDR4 NVDIMM 8GB NVRDIMM-N
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet