1
®
ISL12027, ISL12027A
Real Time Clock/Calendar with EEPROM
The ISL12027 device is a low power real time clock with
timing and crystal compensation, clock/calender, power-fail
indicator, two periodic or polled alarms, intelligent battery
backup switching, CPU Supervisor and integrated 512x8-bit
EEPROM, in 16 Byte per page format.
The oscillator uses an external, low-cost 32.768kHz crystal.
The real time clock tracks time with separate registers for
hours, minutes, and seconds. The device has calendar
registers for date, month, year and day of the week. The
calendar is accurate through 2099, with automatic leap year
correction.
The ISL12027 and ISL12027A Power Control Settings are
different. The ISL12027 uses the Legacy Mode Setting, and
the ISL12027A uses the Standard Mode Setting.
Applications that have V
BAT
> V
DD
will require only the
ISL12027A. Please refer to“Power Control Operation” on
page 15 for more details. Also, please refer to “I
2
C
Communications During Battery Backup and LVR Operation”
on page 24 for important details.
Features
Real Time Clock/Calendar
- Tracks Time in Hours, Minutes and Seconds
- Day of the Week, Day, Month and Year
Two Non-Volatile Alarms
- Settable on the Second, Minute, Hour, Day of the Week,
Day, or Month
- Repeat Mode (Periodic Interrupts)
Automatic Backup to Battery or SuperCap
On-Chip Oscillator Compensation
- Internal Feedback Resistor and Compensation
Capacitors
- 64 Position Digitally Controlled Trim Capacitor
- 6 Digital Frequency Adjustment Settings to ±30ppm
512x8-Bits of EEPROM
- 16-Byte Page Write Mode (32 total pages)
- 8 Modes of BlockLock™
Protection
- Single Byte Write Capability
High Reliability
- Data Retention: 50 years
- Endurance: >2,000,000 Cycles Per Byte
•I
2
C-bus™ Interface
- 400kHz Data Transfer Rate
800nA Battery Supply Current
Package Options
- 8 Ld SOIC and 8 Ld TSSOP Packages
Pb-Free (RoHS Compliant)
Applications
Utility Meters
HVAC Equipment
Audio/Video Components
Modems
Network Routers, Hubs, Switches, Bridges
Cellular Infrastructure Equipment
Fixed Broadband Wireless Equipment
Pagers/PDA
POS Equipment
Test Meters/Fixtures
Office Automation (Copiers, Fax)
Home Appliances
Computer Products
Other Industrial/Medical/Automotive
Pinouts
ISL12027, ISL12027A
(8 LD TSSOP)
TOP VIEW
ISL12027, ISL12027A
(8 LD SOIC)
TOP VIEW
X1
X2
V
BAT
V
DD
RESET
SCL
SDA
GND
1
2
3
4
7
8
6
5
X1
X2
V
BAT
V
DD
RESET
SCL
SDA
GND
1
2
3
4
7
8
6
5
Data Sheet FN8232.8
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
| Intersil (and design) is a registered trademark of Intersil Americas Inc.
I
2
C-bus™ is a trademark of NXP B.V., BlockLock™ is a trademark of Intersil Corporation or one of its subsidiaries
Copyright Intersil Americas Inc. 2005, 2006, 2010. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
August 12, 2010
2
FN8232.8
August 12, 2010
Pin Descriptions
PIN NUMBER
SYMBOL BRIEF DESCRIPTIONSOIC TSSOP
1 3 X1 The X1 pin is the input of an inverting amplifier and is intended to be connected to one pin of an external
32.768kHz quartz crystal. X1 can also be driven directly from a 32.768kHz source.
2 4 X2 The X2 pin is the output of an inverting amplifier and is intended to be connected to one pin of an external
32.768kHz quartz crystal.
3 5 RESET
RESET. This is a reset signal output. This signal notifies a host processor that the “watchdog” time period
has expired or that the voltage has dropped below a fixed V
TRIP
threshold. It is an open drain active LOW
output. Recommended value for the pull-up resistor is 5kΩ. If unused, connect to ground.
4 6 GND Ground.
5 7 SDA Serial Data (SDA) is a bidirectional pin used to transfer serial data into and out of the device. It has an
open drain output and may be wire OR’ed with other open drain or open collector outputs.
6 8 SCL The Serial Clock (SCL) input is used to clock all serial data into and out of the device. The input buffer on
this pin is always active (not gated).
71V
BAT
This input provides a backup supply voltage to the device. V
BAT
supplies power to the device in the event
that the V
DD
supply fails. This pin should be tied to ground if not used.
82V
DD
Power Supply.
Ordering Information
PART
NUMBER
(Notes 1, 2, 3)
PART
MARKING
V
BAT
TRIP POINT
(V)
BSW BIT DEFAULT
SETTING
V
RESET
VOLTAGE
(V)
TEMP. RANGE
(°C)
PACKAGE
(Pb-Free)
PKG.
DWG. #
ISL12027IB27Z 12027 IB27Z V
DD
< V
BAT
BSW = 1 2.63 -40 to +85 8 Ld SOIC M8.15
ISL12027IB27AZ 12027 IB27AZ V
DD
< V
BAT
BSW = 1 2.92 -40 to +85 8 Ld SOIC M8.15
ISL12027IB30AZ 12027 IB30AZ V
DD
< V
BAT
BSW = 1 3.09 -40 to +85 8 Ld SOIC M8.15
ISL12027IBZ 12027 IBZ V
DD
< V
BAT
BSW = 1 4.38 -40 to +85 8 Ld SOIC M8.15
ISL12027IBAZ 12027 IBAZ V
DD
< V
BAT
BSW = 1 4.64 -40 to +85 8 Ld SOIC M8.15
ISL12027IV27Z 2027 I27Z V
DD
< V
BAT
BSW = 1 2.63 -40 to +85 8 Ld TSSOP M8.173
ISL12027IV27AZ 2027 27AZ V
DD
< V
BAT
BSW = 1 2.92 -40 to +85 8 Ld TSSOP M8.173
ISL12027IV30AZ 2027 30AZ V
DD
< V
BAT
BSW = 1 3.09 -40 to +85 8 Ld TSSOP M8.173
ISL12027IVZ 2027 IVZ V
DD
< V
BAT
BSW = 1 4.38 -40 to +85 8 Ld TSSOP M8.173
ISL12027IVAZ 2027 IVAZ V
DD
< V
BAT
BSW = 1 4.64 -40 to +85 8 Ld TSSOP M8.173
ISL12027AIB27Z 12027A IB27Z V
DD
< V
BAT
BSW = 0 2.63 -40 to +85 8 Ld SOIC M8.15
ISL12027AIV27Z 2027A I27Z V
DD
< V
BAT
BSW =0 2.63 -40 to +85 8 Ld TSSOP M8.173
NOTES:
1. Add “-T” suffix for tape and reel. Please refer to TB347
for details on reel specifications.
2. These Intersil Pb-free plastic packaged products employ special Pb-free material sets, molding compounds/die attach materials, and 100% matte
tin plate plus anneal (e3 termination finish, which is RoHS compliant and compatible with both SnPb and Pb-free soldering operations). Intersil
Pb-free products are MSL classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J STD-
020.
3. For Moisture Sensitivity Level (MSL), please see device information page for ISL12027
, ISL12027A. For more information on MSL please see
techbrief TB363
.
ISL12027, ISL12027A
3
FN8232.8
August 12, 2010
Block Diagram
X1
X2
OSCILLATOR
FREQUENCY
TIMER
LOGIC
DIVIDER
CALENDAR
8
CONTROL/
REGISTERS
1Hz
TIME
KEEPING
REGISTERS
ALARM REGS
COMPARE
MASK
RESET
CONTROL
DECODE
LOGIC
ALARM
(EEPROM)
(EEPROM)
SCL
SDA
SERIAL
INTERFACE
DECODER
4k
EEPROM
ARRAY
WATCHDOG
TIMER
LOW VOLTAGE
RESET
REGISTERS
STATUS
(SRAM)
V
DD
V
BAT
32.768kHZ
(SRAM)
BATTERY
CIRCUITRY
SWITCH
OSC COMPENSATION
ISL12027, ISL12027A

ISL12027AIB27Z-T

Mfr. #:
Manufacturer:
Renesas / Intersil
Description:
Real Time Clock REAL TIME CLK/CLNDR W/EEPROM 2 63VSET
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union