Table 4: Identify Device (Continued)
See Note 1 for setting definitions
Word Bit(s) Setting Default Value Description
93 – – – Shall be 0000h for SATA devices
15 – 0b Shall be cleared to zero
14 – 0b Shall be set to one
13 – 0b 1 = Device detected CBLID-above V
IH
0 = device detected CBLID-below V
IL
– – – Device 1 hardware reset result
Device 0 shall clear these bits to zero
Device 1 shall set these bits in accordance with the ATA8, ACS2
specification. See specification for details.
12 – 0b Reserved
11 – 0b 0 = Device 1 did not assert PDIAG-
1 = Device 1 asserted PDIAG-
10–9 – 00b These bits indicate how device 1 determined the device num-
ber:
00 = Reserved
01 = A jumper was used
10 = The CSEL signal was used
11 = Some other method was used or the method is unknown
8 – 0b Shall be set to one
– Device 0 hardware reset result. Device 1 shall clear these bits to
zero.
Device 0 shall set these bits in accordance with the ATA8, ACS2
specification. See specification for details.
7 – 0b Reserved
6 – 0b 0 = Device 0 does not respond when device 1 is selected.
1 = Device 0 responds when device 1 is selected
5 – 0b 0 = Device 0 did not detect the assertion of DASP-
1 = Device 0 detected the assertion of DASP-
4 – 0b 0 = Device 0 did not detect the assertion of PDIAG-
1 = Device 0 detected the assertion of PDIAG-
3 – 0b 0 = Device 0 failed diagnostics.
1 = Device 0 passed diagnostics
2–1 – 00b These bits indicate how device 0 determined the device num-
ber:
00 = Reserved
01 = A jumper was used
10 = The CSEL signal was used
11 = Some other method was used or the method is unknown
0 – 0b Shall be set to one
94 15–8 F 00h Vendor's recommended acoustic management value
7–0 V 00h Current automatic acoustic management value
95 – (O)V 0000h Stream minimum request size
M510DC 2.5-Inch NAND Flash SSD
Device ID
09005aef8633b239
M510DC_2_5_tcge.pdf - Rev. F 9/16 EN
16
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2015 Micron Technology, Inc. All rights reserved.
