Data Sheet ADV7283
Rev. A | Page 5 of 21
Parameter Symbol Test Conditions/Comments Min Typ Max Unit
POWER-DOWN CURRENTS
1
Digital I/O Supply Power-Down
Current
I
DVDDIO_PD
73 µA
PLL Supply Power-Down Current I
PVDD_PD
46 µA
Analog Supply Power-Down Current I
AVDD_PD
0.2 µA
Digital Supply Power-Down Current I
DVDD_PD
420 µA
Total Power Dissipation in Power-
Down Mode
1 mW
1
Guaranteed by characterization.
2
Typical current consumption values are measured with nominal voltage supply levels and an SMPTE bar test pattern.
3
All specifications apply when the I2P core is activated, unless otherwise stated.
VIDEO SPECIFICATIONS
A
VDD
, D
VDD
, and P
VDD
= 1.71 V to 1.89 V, D
VDDIO
= 1.62 V to 3.63 V, specified at operating temperature range, unless otherwise noted.
Specifications guaranteed by characterization.
Table 2.
Parameter Symbol Test Conditions/Comments Min Typ Max Unit
NONLINEAR SPECIFICATIONS
1
Differential Phase DP CVBS input, modulated five-step 0.9 Degrees
Differential Gain DG CVBS input, modulated five-step 0.5 %
Luma Nonlinearity LNL CVBS input, five-step 2.0 %
Signal-to-Noise Ratio (SNR),
Unweighted
SNR Luma ramp 57.1 dB
Luma flat field 58 dB
Analog Front-End Crosstalk 60 dB
Common-Mode Rejection Ratio
2
CMRR 73 dB
LOCK TIME SPECIFICATIONS
Horizontal Lock Range −5 +5 %
40 70 Hz
f
SC
±1.3 kHz
Color Lock-In Time 60 Lines
Synchronization Depth Range 20 200 %
Color Burst Range 5 200 %
Fast Switch Speed
3
100 ms
1
These specifications apply for all CVBS input types (NTSC, PAL, and SECAM), as well as for single-ended and differential CVBS inputs.
2
The CMRR of this circuit design is critically dependent on the external resistor matching on the circuit inputs (see the Input Networks section). The CMRR measurement
was performed with 0.1% tolerant resistors, a common-mode voltage of 1 V, and a common-mode frequency of 10 kHz.
3
Fast switch speed is the time required for the ADV7283 to switch from one analog input (single-ended or differential) to another, for example, switching from A
IN
1 to A
IN
2.