7
Absolute Maximum Ratings
Parameter Symbol Minimum Typical Maximum Unit Notes
Storage Temperature T
S
-40 +85 °C Note 1
Case Temperature T
C
-40 +85 °C Note 1 ,2
Relative Humidity RH 5 95 % Note 1
Module Supply Voltage V
CC
T,R -0.5 3.6 V Note 1, 2
Data/Control Input Voltage V
I
-0.5 V
CC
V Note 1
Sense Output Current - MOD-DEF2 5.0 mA
Recommended Operating Conditions
Parameter Symbol Minimum Typical Maximum Unit Notes
Case Temperature T
C
-5
-40
70
85
°C
°C
Note 3
Module Supply Voltage V
CC
T,R 3.135 3.3 3.465 V Note 3
Data Rate 1.25 Gb/s Note 3
Transceiver Electrical Characteristics
(T
C
= -5 °C to +70 °C, V
CC
T,R = 3.3 V ± 5%) (Tc = -40 °C to +85°C, VccT,R = 3.3 V +/- 5%)
Parameter Symbol Minimum Typical Maximum Unit Notes
AC Electrical Characteristics
Power Supply Noise Rejection
(peak-peak)
PSNR 100 mV Note 4
DC Electrical Characteristics
Module supply current
(T
C
= -5 °C to +70 °C, V
CC
T,R = 3.3 V ± 5%)
(Tc = -40 °C to +85°C, VccT,R = 3.3 V +/- 5%)
I
CC
350
370
mA
Power Dissipation
(T
C
= -5 °C to +70 °C, V
CC
T,R = 3.3 V ± 5%)
(Tc = -40 °C to +85°C, VccT,R = 3.3 V +/- 5%)
P
DISS
1100
1150
mW
Sense Outputs:
MOD-DEF2
RX_LOS
V
OH
2.0 V
CC
T, R+ 0.3 V Note 5
V
OL
0 0.4
Control Inputs:
Transmitter Disable(TX_DISABLE),
MOD-DEF1, 2
V
IH
2.0 V
CC
V Note 5
V
IL
0 0.8 V
Notes:
1. Absolute Maximum Ratings are those values beyond which damage to the device may occur if these limits are exceeded for other than a short
period of time. See Reliability Data Sheet for speci c reliability performance.
2. Between Absolute Maximum Ratings and the Recommended Operating Conditions functional performance is not intended, device reliability
is not implied, and damage to the device may occur over an extended period of time.
3. Operating conditions will vary, depending on model. Recommended Operating Conditions are those values outside of which functional perfor-
mance is not intended, device reliability is not implied, and damage to the device may occur over an extended period of time. See Reliability
Data Sheet for speci c reliability performance later when it is ready.
4. MSA-speci ed lter is required on the host board to achieve PSNR performance over the frequency range 10 Hz to 2 MHz.
5. LVTTL, external 4.7-10 K pull-Up resistor required for MOD-DEF 1 and MOD-DEF 2.
