TEA19162T All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
Product data sheet Rev. 1 — 10 March 2016 23 of 30
NXP Semiconductors
TEA19162T
PFC controller
V
scp(stop)
stop short-circuit
protection voltage
0.35 0.40 0.45 V
V
scp(start)
start short-circuit
protection voltage
0.45 0.50 0.55 V
t
d(start)
start delay time after short-circuit protection removed 3.30 3.62 4.00 ms
I
pu(rst)SNSBOOST
reset pull-up
current on pin
SNSBOOST
fast latch reset; V
SNSBOOST
=1.5V 245 210 175 A
V
pu(rst)SNSBOOST
reset pull-up
voltage on pin
SNSBOOST
fast latch reset 1.94 2.00 2.06 V
I
prot(SNSBOOST)
protection current
on open pin
SNSBOOST
pin SNSBOOST = open - 35 - nA
V
ovp(stop)
stop overvoltage
protection voltage
2.59 2.63 2.67 V
V
ovp(start)
start overvoltage
protection voltage
2.47 2.53 2.59 V
V
hys(ovp)
overvoltage
protection
hysteresis voltage
on pin SNSBOOST
V
stop(ovp)
V
start(ovp)
0.07 0.10 0.13 V
Soft start (pin SNSCUR)
t
start(soft)
soft start time 3.30 3.62 4.00 ms
V
start(soft)init
initial soft start
voltage
100 125 155 mV
Soft stop (pins SNSBOOST and PFCCOMP)
V
det(L)SNSBOOST
LOW-level
detection voltage
on pin SNSBOOST
soft stop 2.74 2.80 2.86 V
V
det(H)SNSBOOST
HIGH-level
detection voltage
on pin SNSBOOST
soft stop 3.17 3.23 3.29 V
I
ch(stop)soft
soft stop charge
current
pin PFCCOMP 36 32 28 A
t
d(ovp)
overvoltage
protection delay
time
pin SNSBOOST 80 100 120 s
External and internal overtemperature measurement
I
en(NTC)
NTC enable
current
pin SNSMAINS; NTC measurement;
mains measurement period; falling slope
2.0 2.5 3.0 A
I
o(SNSMAINS)
output current on
pin SNSMAINS
214 200 186 A
Table 6. Characteristics …continued
T
amb
=25
C; V
SUPIC
= 20 V; all voltages are measured with respect to ground (pin 2); currents are positive when flowing into
the IC; unless otherwise specified.
Symbol Parameter Conditions Min Typ Max Unit
