P89LPC915_916_917_5 © NXP B.V. 2009. All rights reserved.
Product data sheet Rev. 05 — 15 December 2009 16 of 75
NXP Semiconductors
P89LPC915/916/917
8-bit microcontrollers with accelerated two-clock 80C51 core
P0.7/T1/KBI7/CLKOUT 11 I/O P0.7 — Port 0 bit 7.
I/O T1 — Timer/counter 1 external count input or overflow output.
I KBI7 — Keyboard input 7.
O CLKOUT — Clock output.
P1.0 to P1.5 I/O, I
[1]
Port 1: Port 1 is a 6-bit I/O port with a user-configurable output type,
except for three pins as noted below. During reset Port 1 latches are
configured in the input only mode with the internal pull-up disabled. The
operation of the configurable Port 1 pins as inputs and outputs depends
upon the port configuration selected. Each of the configurable port pins
are programmed independently. Refer to
Section 8.13.1 “Port
configurations” and Table 15 “Static characteristics” for details. P1.2 to
P1.3 are open drain when used as outputs. P1.5 is input only.
All pins have Schmitt triggered inputs.
Port 1 also provides various special functions as described below:
P1.0/TXD 10 I/O P1.0 — Port 1 bit 0.
O TXD — Transmitter output for serial port.
P1.1/RXD 9 I/O P1.1 — Port 1 bit 1.
I RXD — Receiver input for serial port.
P1.2/T0/SCL 8 I/O P1.2 — Port 1 bit 2 (open-drain when used as output).
I/O T0 — Timer/counter 0 external count input or overflow output (open-drain
when used as output).
I/O SCL — I
2
C serial clock input/output.
P1.3/
INT0/SDA 7 I/O P1.3 — Port 1 bit 3 (open-drain when used as output).
I
INT0 — External interrupt 0 input.
I/O SDA — I
2
C serial data input/output.
P1.4/
INT1 6 I P1.4 — Port 1 bit 4.
I
INT1 — External interrupt 1 input.
P1.5/
RST 3 I P1.5 — Port 1 bit 5 (input only).
I
RST — External Reset input during power-on or if selected via UCFG1.
When functioning as a reset input, a LOW on this pin resets the
microcontroller, causing I/O ports and peripherals to take on their default
states, and the processor begins execution at address 0. Also used
during a power-on sequence to force ISP mode. When using an
oscillator frequency above 12 MHz, the reset input function of P1.5
must be enabled. An external circuit is required to hold the device in
reset at power-up until V
DD
has reached its specified level. When
system power is removed V
DD
will fall below the minimum specified
operating voltage. When using an oscillator frequency above
12 MHz, in some applications, an external brownout detect circuit
may be required to hold the device in reset when V
DD
falls below the
minimum specified operating voltage.
Table 6. P89LPC917 pin description
…continued
Symbol Pin Type Description