NCV7462
www.onsemi.com
47
CAN Transceiver
Control
CAN_DIS CAN_LSTO CAN Transceiver In Normal Mode
0 0 default CAN Transmitter and Receiver Enabled
0 1 CAN Listen Only (Transmitter will not react to TxDC signal)
1 X CAN Transceiver Disabled
LIN Slope Control
LIN_SLOPE Change of the LIN Slope
0 default High slew rate (as per LIN specification)
1 Low slew rate
TxDL Time−out Timer
TxDL_TO.1 TxDL_TO.0 Dominant TxD Time−out Configuration of the LIN Interface
0 0 default Set the timer to typ. 55 ms
0 1 Set the timer to typ. 13 ms
1 X Time−out timer disabled
FSO Function Disable
FSO_DIS OUT3/FSO Function
0 default OUT3 pin is driven by internal FSO signal
1 OUT3 pins is a general−purpose high−side driver
CONTROL_1
CONTROL_1
D15 D14 D13 D12 D11 D10 D9 D8
RW RW RW RW RW RW RW RW
WU_CAN_DIS WU_LIN_DIS WU_TIM_EN.1 WU_TIM_EN.0 WU3_DIS WU2_DIS WU1_DIS WU3_PUD
D7 D6 D5 D4 D3 D2 D1 D0
RW RW RW RW RW RW RW RW
WU2_PUD WU1_PUD WU3_T.1 WU3_T.0 WU2_T.1 WU2_T.0 WU1_T.1 WU1_T.0
CAN Wakeup
Disable
WU_CAN_DIS Disables CAN Wakeup in Standby or Sleep Mode
0 default CAN Wakeup Enabled
1 CAN Wakeup Disabled
LIN Wakeup
Disable
WU_LIN_DIS Disables LIN Wakeup in Standby or Sleep Mode
0 default LIN Wakeup Enabled
1 LIN Wakeup Disabled
Timer Wakeup
Control
WU_TIM_EN.[1:0] Enables Cyclic (timer controlled) Wakeup from Standby or
Sleep Mode
0 0 default Timers 1/2 are not used as wakeup sources
0 1 Wakeup generated based on Timer 1
1 0 Wakeup generated based on Timer 2
1 1 Wakeup generated based on Timer 1