© Semiconductor Components Industries, LLC, 2016
April, 2016 − Rev. 0
1 Publication Order Number:
NCV7710/D
NCV7710
Door-Module Driver-IC
(Lock Driver-IC)
The NCV7710 is a powerful Driver−IC for automotive body control
systems. The IC is designed to control lock motor in the door of a
vehicle. With the monolithic full−bridge driver stage, the IC is able to
control lock motor. The NCV7710 is controlled thru a 24 bit SPI
interface with in−frame response.
Features
• Operating Range from 5.5 V to 28 V
• Two High−Side and Two Low−Side Drivers Connected as
Half−bridges
♦ 2 Half−bridges Iload = 6 A; Rdson = 150 mW @ 25°C
• Programmable Soft−Start Function to Drive Loads with Higher
Inrush Currents as Current Limitation Value
• Support of PWM Control Frequency Outside the Audible Noise
• Support of Active Freewheeling to Reduce Power Dissipation
• Multiplex Current Sense Analog Output for Advanced Load
Monitoring
• Very Low Current Consumption in Standby Mode
• Charge Pump Output to Control an External Reverse Polarity
Protection MOSFET
• 24−Bit SPI Interface for Output Control and Diagnostic
• Protection Against Short Circuit, Overvoltage and Over−temperature
• Downwards Pin−to−pin and SPI Registers Compatible with
NCV7707
• SSOP36−EP Power Package
• AEC−Q100 Qualified and PPAP Capable
• These Devices are Pb−Free, Halogen Free/BFR Free and are RoHS
Compliant
Typical Applications
• De−centralized Door Electronic Systems
• Rear Door Electronic Unit
• Body Control Units (BCUs)
• Several H−bridge Applications
SSOP36−EP
DQ SUFFIX
CASE 940AB
MARKING DIAGRAM
www.onsemi.com
NCV7710
AWLYYWWG
NCV7710 = Specific Device Code
A = Assembly Location
WL = Wafer Lot
YY = Year
WW = Work Week
G = Pb−Free Package
See detailed ordering and shipping information on page 20 of
this data sheet.
ORDERING INFORMATION
