Based on Microchip's low-power IEEE 802.11b / g / n Wi-Fi module, the RN1810, the RN1810 PICtail / PICtail plus daughter board allows customers to easily develop Wi-Fi applications using Microchip’s 8-, 16-, and 32-bit PIC® microcontrollers. The kit includes a fully integrated TCP / IP stack allowing for a simple serial to Wi-Fi connection to the microcontroller. The board features a USB interface for easy plug-and-play development with a PC. The board is also compatible with the Explorer 16 development board (DM240001), PICDEM.net2 development board (DM163024), and PIC32 starter kit (DM320001) with I/O expansion board (DM320002).
| Features |
|
|
- Enables rapid development with the RN1810 low-power 802.11b / g / n Wi-Fi module
- On-board USB-to-UART bridge for easy development from PC
- On-board connection and data status LEDs
|
|
- PICtail / PICtail plus interfaces for connection to Microchip Explorer 16 (DM240001) , PIC32 I/O expansion board (DM320002), or PIC18 Explorer (DM183032) development boards
|
| Module Features |
|
|
- IEEE 802.11b / g / n compliant transceiver
- 2.4 GHz IEEE 802.11n single stream 1 x 1
- UART interface to host controller (4-wire including RTS / CTS)
- Configured using simple ASCII commands
- Supports infrastructure and SoftAP networking modes
- Built-in networking applications: IPv4 / IPv6, TCP, UDP, DHCP, DNS, ICMP, ARP, HTTP, FTP, SNTP, and SSL / TLS
|
|
- Supports infrastructure and SoftAP networking modes
- Complete on-board TCP / IP networking
- Upgrade firmware over the air using TFTP
- Supports Wi-Fi protected setup (WPS)
- Modular certified for the United States (FCC), Canada (IC), Europe, Australia, New Zealand, Korea, Taiwan, and Japan
|
